Avanti WD361 Kullanım Kılavuzu - Sayfa 10

Su Sebili Avanti WD361 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Avanti WD361 17 sayfaları. Avanti water dispenser wd361 instruction manual

Avanti WD361 Kullanım Kılavuzu

OPERATING YOUR WATER DISPENSER

? Steps to replace water bottles

Use a clean cloth to wipe off neck of bottle.
Remove cap.
Carefully lift bottle (approx. 40 lbs.) using your legs and not your back. Do not place hands on
opening of bottle while placing in reservoir.
Insert the water bottle on the water intake over reservoir opening so it settles properly on it.
Wipe off any water which may have splashed on dispenser top.
When a new bottle is installed you must open the hot water faucet and remove no less than 4 full
cups of water to insure the water flows properly and the water reservoir is at the proper level.

? Electrical Connection

This appliance should be properly grounded for your safety. The power cord of this appliance is equipped
with a three-prong plug which mates with standard three prong wall outlets to minimize the possibility of
electrical shock.
Plug the appliance into an exclusive properly installed-grounded wall outlet. Do not under any
circumstances cut or remove the third (ground) prong from the power cord. Any questions concerning
power and or grounding should be directed toward a certified electrician or an authorized Avanti Products
service center.
This appliance requires a standard 115/120-volt. 60Hz electrical outlet with three-prong ground.
The cord should be secured behind the appliance and not left exposed or dangling to prevent accidental
injury.
Do not use an adapter plug with this appliance.
Do not use an extension cord with this appliance. If the power cord is too short, have a qualified
electrician or service technician install an outlet near the appliance.

? Cold Water Control

Turn the cooling switch on. The green indicator will be lit on and the process begins. When the water
reaches the right temperature the green light goes off automatically.

? Hot Water Control

Turn the heating switch on, the red indicator will be lit on and the heating process starts. When the
water reaches the right temperature the red light goes off automatically.
down to approx. 80º C (176º F), the red indicator will glow again and another heating process starts.
NOTE:
THE HOT WATER FAUCET HAS A CHILD-SAFETY GUARD ATTACHMENT.
To dispense hot water:
Slide red safety button to the left and hold while pressing downward on hot water faucet to dispense
hot water.
Safety button will return to its original position when faucet is released.
When the temperature goes
10