Avanti WDE98PS Kullanım Kılavuzu - Sayfa 7

Su Sebili Avanti WDE98PS için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Avanti WDE98PS 15 sayfaları. Avanti products water dispenser - electric cold water dispenser user manual

Sayfayı Yazdır
Slide child safety button then push the hot water faucet until water comes out, then stop.
Plug the dispenser into the electrical outlet. We are ready to complete the first cycle. In order to do
that, wait for the hot water to reach temperature in approximately 10 minutes, and then wait for the
cold to reach temperature (another 40 minutes, approximately).
Unplug the dispenser from the electrical outlet. Proceed to drain the water from the faucets one at a
time until no more water remains.
(Note: To facilitate this operation, use a large container).
Then, drain any water left in the tanks by opening the drain plug located on the back, until it drains
completely.
Proceed to close the drain cap.
Remove the cap from the 5-gallon bottle and use a clean cloth to wipe off the neck of the bottle.
Place the 5-gallon bottle of water on the water intake, allow water to stand for approximately one
minute.
Push water faucet buttons to insure water flows from both faucets.
Plug dispenser back into the electrical outlet.
Now you are ready to use your water dispenser.
NOTE: Your water dispenser has been cleaned and sanitized befo re leaving the
factory, but in case a taste problem develops, place two tablespoons of
baking soda and add tap water. Fill water tank again and repeat basic
operations previously outlined, except turn hot water function "OFF" to
avoid leaving residues in hot water tank.
ATTENTION:
If you do not plan to use the water heating function for more than three days, we
recommend that you turn off the hot water function.
IMPROPER USE OF THE GROUNDED PLUG CAN RESULT IN THE RISK OF ELECTRICAL SHOCK. IF
THE POWER CORD IS DAMAGED, HAVE IT REPLACED BY AN AUTHORIZED AVANTI PRODUCTS
SERVICE CENTER.

Steps To Replace Water Bottles

Remove cap.
?
Use a clean cloth to wipe off neck of bottle.
?
Carefully lift bottle (approx. 40 lbs.) using your legs and not your back. Do not place hands on
?
opening of bottle while placing in reservoir.
Insert the water bottle on the water intake over reservoir opening so it settles properly on it.
?
Wipe off any water which may have splashed on dispenser top.
?
When a new bottle is installed you must open the hot water faucet and remove no less than 4 full
?
cups of water to insure the water flows properly and the water reservoir is at the proper level.
When a new bottle is installed you mus t open the hot water faucet and remove no less than 4 full cups of
water to insure the water flows properly and the water reservoir is at the proper level.
?
WARNING

OPERATING YOUR WATER DISPENSER

?
7