HIKVISION DS7208HVI-ST Hızlı Başlangıç Kılavuzu
DVR HIKVISION DS7208HVI-ST için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. HIKVISION DS7208HVI-ST 9 sayfaları. Ds-7200hvi-st series dvr
Ayrıca HIKVISION DS7208HVI-ST için: Teknik Kılavuz (13 sayfalar), Ürün/Bakım Kılavuzu (18 sayfalar), Teknik Kılavuz (9 sayfalar)
Sayfayı Yazdır
Quick Start Guide
DS-7200HVI-ST Series DVR
Menu Structure
The menu structure of the DS-7200HVI-ST Series DVR is as
followed:
Startup and Shutdown
Proper startup and shutdown procedures are crucial to
expanding the life of your DVR.
To start your DVR:
1. Ensure the power supply is plugged into an electrical
outlet. It is HIGHLY recommended that an
Uninterruptible Power Supply (UPS) is used in
conjunction with the unit.
2. Press the POWER switch on the rear panel. After the
power has been started up, the POWER indicator will
light green.
To shut down the DVR:
1. Enter the Shutdown menu by clicking on Menu >
ShutDown.
2. Select the ShutDown button.
3. Click the Yes button.
Using the Setup Wizard
By default, the Setup Wizard will start once the DVR has
loaded. The Setup Wizard will walk you through some of the
(V1.0.2)
more important settings of your DVR. If you do not wish to
use the Setup Wizard at this time, click the Cancel button.
You may also choose to use the Setup Wizard at a later time
by leaving the "Start Wizard when DVR starts?" checkbox
checked.
To start using the Setup
Wizard:
1. Click the Next button
2. This will take you to
3. Navigate to the Admin
4. Enter the admin password into the Admin Password
5. To change the admin
6. Click the Next button. This will take you to the HDD
7. To start HDD
8. If a new HDD was
9. After the HDD has been initialized, click the OK button
10. Click the Next button. This will take you to the Record
Quick Start Guide - DS-7200HVI-ST Series DVR
on the Wizard
window.
the User Permission
window.
Password input field.
input field. By default,
the password is
12345.
password, check the
New Admin
Password checkbox.
Enter the new password and confirm the password in the
given fields.
Management
window.
management, click the
Enter button.
recently installed, select the HDD from the list to
initialize it. Initializing the HDD will format and remove
all data from it.
which will take you back to the Setup Wizard window.
1