Garden Lights P1 Series Kurulum Talimatları

Aydınlatma Ekipmanları Garden Lights P1 Series için çevrimiçi göz atın veya pdf Kurulum Talimatları indirin. Garden Lights P1 Series 2 sayfaları.

Sayfayı Yazdır
Garden Light LED
800-511-2099
www.gardenlightled.com
LUMINAIRE INSTALLATION
Surface Mount Method
1.
To prevent electrical shock, unplug transformer from the electrical
outlet before installation or service of Luminaire or Driver.
2.
Pre-drill the surface that the Luminaire will be mounted to.
3.
Ensure there is a cavity in or under the mounting surface to house
the wire connections between the luminaire and the main supply
lines.
4.
Strip the two Luminaire Leads to the appropriate length and attach
them to the Main Supply Lines using Listed Wet Location Wire
Connectors.
5.
Fasten luminaire to the surface using the appropriate screws.
(see Figure 2.)
Stake Mount Method
1.
To prevent electrical shock, unplug transformer from the electrical
outlet before installation or service of Luminaire.
2.
Run the Luminaire Leads through the top of the Ground Stake and
thread Luminaire onto the Ground Stake.
3.
Drive the Luminaire / Ground Stake assembly into the ground at
the desired location (using a hammer on the edge of the Ground
Stake if necessary).
4.
Secure the Luminaire in place using the Locking Screw if desired.
5.
Strip the two Luminaire Leads to the appropriate length and attach
them to the Main Supply Lines using Listed Wet Location Wire
Connectors. To protect the wire connection, route the wire in close
proximity to the Luminaire.
SUITABLE FOR DOWNWARD LIGHTING ONLY
IF INSTALLED IN A MANNER NOT OUTLINED IN THIS
DOCUMENT, FACTORY WARRANTY MAY BE VOID.
NOTES:
Garden Light LED Drivers self-regulate to keep the LED brightness the
same throughout the en re voltage range, ensuring a consistent output
among Luminaires. It is not necessary to balance the voltage to each
Luminaire.
***Use only wire connectors Listed for wet loca ons. Contact Garden Light
LED for suitable connectors. (800-511-2099)
***If addi onal wire is needed to connect the Luminaire to the low voltage
transformer, contact Garden Light LED. (800-511-2099)
If you have any questions regarding installation or Garden Light LED
luminaires, please call 800-511-2099 and our knowledgeable staff
will assist you.
P1 SERIES INSTALLATION INSTRUCTIONS
NOTE: Use Garden Light LED transformers only - Garden Light LED will not repair or replace
under warranty any luminaires or drivers that have been damaged as a result of using other
manufacturer's equipment.
This Garden Light LED luminaire uses LED technology that has an operating voltage range of
10.5 - 18 Volts AC. Garden Light LED recommends using a 15 Volt tap.
WARNING - RISK OF ELECTRIC SHOCK: This luminaire must not be installed within 10FT
(3.05m) of a pool, spa or fountain.
Low voltage wire is intended for shallow burial only and should be at a maximum depth of 6
inches (152mm).
(see Figure 1.)
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE
Follow all NEC guidelines and local electrical codes.
LISTED FOR OUTDOOR USE ONLY
Figure 1.
Drill template
on reverse side
of page.
Figure 2.
A15
Rev 4-15