HIKVISION HiWatch Series Hızlı Başlangıç Kılavuzu - Sayfa 7

DVR HIKVISION HiWatch Series için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. HIKVISION HiWatch Series 15 sayfaları. Hd turret and bullet camera
Ayrıca HIKVISION HiWatch Series için: Hızlı Başlangıç Kılavuzu (20 sayfalar), Hızlı Başlangıç Kılavuzu (18 sayfalar), Nasıl Yapılır (4 sayfalar), Kullanıcı Kılavuzu (15 sayfalar), Kullanıcı Kılavuzu (15 sayfalar)

HIKVISION HiWatch Series Hızlı Başlangıç Kılavuzu
Front Panel Plug-Pull Installation
Front panel plug-pull installation is applicable when it requires to open the device front panel with key.
Fix mounting ears to HDD with screws. Refer to Figure 2-4.
Use attached key to unlock the front panel, and press buttons on both sides to open the front panel. Refer to Figure 2-5.
Insert the HDD until it is firmly fixed. Refer to Figure 2-6
You can repeat the steps above to install other HDDs.
Close the front panel and lock it with key.
Fix Mounting Ear
Fix-on-Bottom Installation
Fix-on-bottom installation is applicable when it requires to install the HDD at the internal bottom.
Unfasten screws on each panel to remove the device cover. Refer to Figure 2-7.
Connect the data cable and power cable. Refer to Figure 2-8.
Match HDD screw threads with the reserved holes on the device bottom, and fix HDD with screws. Refer to Figure 2-9.
You can repeat the steps above to install other HDDs.
Reinstall the device cover and fasten screws.

RS-485 and Controller Connection

Use RS- 485 interface to connect PTZ with DVR.
Before you start
Ensure both controller and DVR are grounded.
Pull out the pluggable block at the RS-485 terminal block.
Press and hold the orange part of the pluggable block, insert signal cables into slots.
Release the orange part. Ensure signal cables are in tight.
Connect A+ on PTZ to D+ on terminal block and B- on controller to D- on terminal block. Fasten stop screws.
Plug pluggable block back into terminal block.
Digital Video Recorder Quick Start Guide
Remove Cover
Open Front Panel
Connect Cable
Controller Connection
6
Insert HDD
Fix HDD