Avantree BTHS-063 Kullanıcı Kılavuzu - Sayfa 5

Kulaklık Avantree BTHS-063 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Avantree BTHS-063 6 sayfaları. Stereo wireless headphones
Ayrıca Avantree BTHS-063 için: Kullanıcı Kılavuzu (19 sayfalar)

Sayfayı Yazdır

for 2s

Short Press

Siri

Volume+/-

Short press

End call

power button

Redial last

Double click

number

power button

Clear

Long Press

pairing list

Volume+/- 5s

Press button

Hardware

Volume+ &

Restoration

power button

Mic Mute on

Long press

call

Volume-

When in charging, the red LED will be always on; once the energy is full,it will go

Charging

off

When the Audio cable is plug in, the headphone will play music in line-in

Line in

mode(suggestion: pls disconnect bluetooth manually, or the music quality will be

affected)

When power is less than 10%, the battery voltage will lower 3.3V, then there will

be a voice prompt "dududu", while the RED LED flashes twice per second--this

low battery

alarm occurs every 1minutes. when the voltage is lower 3.1V,the earphone will

shut down automatically

Pairing the headphones with a computer

1.Before pairing the headphone with your computer, please

support bluetooth function. If

(preferably version 2.1 or above).

2. Insert the bluetooth adapter to the computer, and make sure the bluetooth function of the computer is

already activated.

3. Press the power button about 5s when the headphone is at power off status. It will go into paring mode

when the blue and red LED light flash alternately, while you can also hear a prompt

4. Open the bluetooth software and choose to search the bluetooth device, and after few seconds, the

names of bluetooth device will list out.

6. Click the pairing name "B036"to pair, when there is a prompt "beep", this means your headphone is

paired successfully .

incoming

Short Press both Volume+/- at the same time

when the device is connected

Short Press the power button can end a call

while the call in progress

Double click power button can do redial last

number

At the power on status, Long Press button

Volume+/- for 5s, the headphone will clear up

the pairing list and enter into pairing mode

Press both Volume+ & power button at the

same time, the hardware will reset

Long press Volume-for 3s at call status, the

headphone will go into/out mute

not, you must

purchase

RED LED flash

fast

alternating

pattern

(200mS)

RED

BLUE LED light

on 2s

make sure your computer or laptop can

bluetooth

adapter

and