Avantree TWS109 Kullanıcı Kılavuzu - Sayfa 4

Kulaklık Avantree TWS109 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Avantree TWS109 5 sayfaları. True wireless earbuds
Ayrıca Avantree TWS109 için: Kullanıcı Kılavuzu (6 sayfalar)

Sayfayı Yazdır

on the LEFT earbud for 2 seconds, the LED will light on

BLUE

2) Press & hold

and then start flashing

twice every 5s – indicating it has connected with the RIGHT earbud.

3) Search and select "Avantree TWS109" on your device's Bluetooth menu to connect.

After first use (Reconnect), please >

1) Ensure Bluetooth on your device is on.

2) Power on both earbuds - From OFF state, press & hold

on BOTH earbuds for 2s until both LEDs light on BLUE.

NOTE: If it fails to reconnect, please double tap

on the RIGHT earbud or click "Avantree TWS109" once on your

device to manually connect.

After first use (Connect to A DIFFERENT device), please >

1) Make sure that the Bluetooth on the previously connected device is off.

2) Power on the RIGHT earbud. The LED will light on

BLUE

then flash for about 10s.

3) Then it will enter pairing mode automatically – LED flashes

BLUE

RED

alternately.

4) Power on the LEFT earbud. The LED will light on

BLUE

then start flashing

BLUE

twice every 5s – indicating

that it has connected with the RIGHT earbud.

5) Search and select "Avantree TWS109" on your device's Bluetooth menu to connect.

Mono earbud use>

Only the RIGHT earbud can be used individually for mono playback or calls. For track controls, please use your

connected mobile device.

Charging

When you hear a voice prompt "battery low" and see the LED flashing

RED

four times every 2 min, you should

charge the earbuds.

Please use a DC 5V / 0.5-2A USB wall charger /car charger / computer USB port that is powered on to charge

with the included Micro USB cable. It normally takes about 1.5 hours to fully charge. The LEDs on the earbuds

will illuminate

RED

while charging, and automatically turn off when the charging is done.

Reset / clear pairing history

If the earbuds exhibit abnormal behavior, e.g. can't pair with device, sound cutting in & out, static noise, please

'reset' pairing history: