Jancy Engineering Slugger MCCS14-2 Operatör El Kitabı - Sayfa 11
Kesici Jancy Engineering Slugger MCCS14-2 için çevrimiçi göz atın veya pdf Operatör El Kitabı indirin. Jancy Engineering Slugger MCCS14-2 16 sayfaları. 14" metal cutter
Sayfayı Yazdır
basic saw operations (
.)
cont
CHANGING THE CUT ANGLE
The vise can be adjusted to the right from 0 to 45°.
1. Using the arbor wrench loosen the two bolts on the vise, then set
the vise at the desired angle.
2. Tighten the two bolts.
RETRACTABLE BLADE GUARDS
When the saw head is pressed down, the main blade guard (Item 18) and small
blade guard (Item 8) appropriately open to expose the blade.
WORK PIECE CLAMPING
Position work in vise so that if a jam occurs, the blade will not move the work
piece in the vise. Clamp it securely.
Angle bar should be clamped with both legs down as shown.
Generally the saw cuts most efficiently if the blade is cutting the thinnest
section at any time.
RECOMMENDED CUTTING CAPACITY
WARNING: Use of tool for greater than recommended capacities may lead to motor burnout
and possible electric shock.
Note: Cutting through any cross sectional area of material thicker than 1/2" tends to load up the blade, and this will
cause your tool to work harder.
11