Jands 4PAK Kullanım Kılavuzu - Sayfa 4

Kontrolör Jands 4PAK için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Jands 4PAK 6 sayfaları. Four channel controller/dimmer

JANDS

Dimmer Operation

After unpacking, check for any obvious faults or defects. If any are apparent, return the unit to the place of

purchase.

Unwrap the power cord and plug into a GPO. Plug four lamps into the four output sockets and switch the

power on at the wall and the rear panel. Advance the Master fader and a channel fader. The mimic LED

for that channel will light, at an intensity corresponding to the lamp connected to that channel.

The Master fader provides overall control over all four output channels, and also provides level control for

the chaser.

The Flash buttons below the channel faders will always flash to full irrespective of the Master level.

To operate the chaser, advance the Master fader, and press the Chaser On switch. The Chase rate is

adjustable from zero to maximum by the Rate fader on the left. To disable the chaser, press Chaser On

again.

If desired, the chaser can be triggered by audio sound levels at the

. With the chaser on, press

the Audio switch. In the absence of any sound, the chaser will now step at a rate determined by the rate

control as before. Any loud sounds will be detected by the internal microphone and advance the chaser

accordingly.

Both the Chaser and Audio functions have LED indicators showing when each function is on.

Note that at no time should the total load on the

exceed 2400Watts. If this occurs, the overload

circuit breaker will trip. Take the Master to zero before resetting the overload circuit breaker. This

maximum power (2400W at 240V AC) may be supplied by one channel, or any combination of channels.

For example: If four 2400W lamps were connected to the four outputs, only one could ever be fully on at

any one time. Eight 300W lights (such as PAR 56s) may be run continuously at "full" without risk of

overload.

With care, the

will require little or no maintenance. Covering the unit while not in use prevents

entry of dust into the faders, increasing their useful life. This also minimises the risk of entry of liquids inside

the chassis, which would be both damaging to the unit and dangerous to the operator. During cleaning, do

not spray directly onto the unit, but onto a rag and wipe clean.

Revision 0

December 2003

- 4 -

Operating Guide