Jandy SFTM PRO Series Kurulum ve İşletim Verileri - Sayfa 7
Su Filtrasyon Sistemleri Jandy SFTM PRO Series için çevrimiçi göz atın veya pdf Kurulum ve İşletim Verileri indirin. Jandy SFTM PRO Series 16 sayfaları.
Sayfayı Yazdır
3B. Filter Location
1.
Select a well-drained area, one that does not
flood when it rains. Damp, non-ventilated areas
should be avoided.
2.
Provide solid mounting for the filter and pump
system. Install system on a concrete slab or solid
concrete blocks to avoid risk of settlement. Do
not use sand to level the filter, as the sand will
wash away. Filter systems, once loaded with
media, can weigh up to 800 lbs.
3.
Install electrical controls at least five (5) feet
from the filter. This will allow enough room to
stand away from the filter during start-up.
4.
Allow sufficient clearance around the filter to
permit a visual inspection of the entire system
(see Fig. 4).
WARNING
Water discharged from an improperly positioned filter
or valve can create an electrical hazard and can dam-
age property.
MPV = Multiport Valve
Heater
Pool Return
Figure 5. Basic Pool/Spa Combination Plumbing
5.
6.
Figure 4. Filter Location
Waste
Port
MPV
Outlet
Port
Filter
Spa Make-up
From
Pool Drain
Check
Valve
Spa Return
From Pool
Skimmer
Position the filter to safely direct water drainage.
Align the pressure release valve to safely direct
purged air or water.
If the system is to be located above water level it
can be raised 2.5 ft., without affecting the pump
efficiency. A check valve is recommended on
the suction line to the pump.
6" MINIMUM CLEARANCE
FILTER
Filter
Pump
Inlet
Port
From Spa
Skimmer
Page 7
6" MINIMUM
CLEARANCE
Hair/Lint
Pot
Spa Drain