Garden Treasures 226390 Hızlı Başlangıç Kılavuzu - Sayfa 2

Dış Mekan Çeşmesi Garden Treasures 226390 için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. Garden Treasures 226390 2 sayfaları. Brick wall fountain with submerged light

Sayfayı Yazdır

Estimated Assembly Time: Approximately 10 minutes

Note: Assemble fountain on a level surface.

Make certain all connections are secure.

Attach pump hose (E) to pump (B) and place the pump flat in

the reservoir. Place the submersible lamp (C) in a proper place

in the front of the reservoir. Run the pump cord out through the

notch at the back panel.

Hang fountain (A) on wall using the hook on back of fountain.

Add clean water into the reservoir. The water level should be

approx. 1" below the edge of the reservoir.

Attach pump cord to transformer (D), plug the transformer into

an outlet. Switch on and your fountain will start to function as

intended. Water will flow out from the fountain bonsai

(Note: To prevent splashing, wet the watering surface before

using.) with light on the watering surface. You can adjust the

direction of light to beautify the illumination.

Submersible Lamp Assembly Diagram

Troubleshooting Guide

Problem

Pump operates, but there is no

water flow.

Pump operates, but there is no

water flow and pump is fully

submerged and pump hose has no

kinks.

Remedy

1. Make certain pump is fully submerged.

2. Make certain pump hose has no kinks.

1. Remove pump hose from pump outlet.

2. Clean pump hose.

3. Set pump in water (outlet side up).

4. Once water begins to flow, reattach pump hose.

NOTE: Diagram shown is for illustrative purposes only.

Printed in China

Model No. F41062CA