Garden Treasures Living BSH-A-SS Manuel - Sayfa 9

Veranda Isıtıcı Garden Treasures Living BSH-A-SS için çevrimiçi göz atın veya pdf Manuel indirin. Garden Treasures Living BSH-A-SS 13 sayfaları. Gas patio heater

Sayfayı Yazdır

ASSEMBLY INSTRUCTIONS

15. Connect gas hose and regulator (P) to control

box assembly (I). Do not cross-thread.

WARNING: Ensure gas hose does not contact any

high temperature surfaces, or it may melt and leak

causing a fire.

16. Screw gas hose and regulator (P) to propane

cylinder (not included). Do not cross-thread.

WARNING: Use a standard 20 lb. propane cylinder

only.

Use this heater only with a propane vapor

withdrawal supply system. See chapter 5 of the

standard for storage and handling of liquefied

petroleum gas, ANS/NFPA 58. Your local library or

fire department should have this book.

A minimum supply pressure of 0.4 P.S.I. is required

for the purpose of input adjustment for propane

gas. Storage of an appliance indoors is permissible

only if the cylinder is disconnected and removed

from the appliance. A cylinder must be stored

outdoors in a well-ventilated area out of the reach

of children. A disconnected cylinder must have dust

caps tightly installed and must not be stored in a

building, garage or any other enclosed area. The

minimum permissible gas supply pressure of 10

W.C. is required for purpose of input adjustment. A

minimum of 17,000 BTUs per hour is the required

input rating for a heater with a rating less than full.

The pressure regulator and hose assembly

supplied with the appliance must be used.

The installation must conform with local codes,

or in the absence of local codes,with national fuel

gas code, ANS Z223.1/NFPA54, natural gas and

propane Installation Code, CSA B149.1, or propane

storage and handling code, B149.2.

OPERATING INSTRUCTIONS

To check for a leak:

1. Make 2-3 oz. leak check solution (one part

liquid dishwashing detergent and three parts

water).

2. Apply several drops of solution where

regulator connects to cylinder and to all hose

and valve connections

3. Make sure all patio heater and light valves

are OFF.

4. Turn cylinder valve ON.

If bubbles appear at any connection, there is a

leak.

1. Turn cylinder valve OFF.

2. If leak is at regulator/cylinder valve connection:

Disconnect, reconnect, and perform another

leak check. Apply the soapy solution to all hose and

valve connections. If you continue to see bubbles

after several attempts, cylinder valve is defective

and should be returned to cylinder's place of

purchase.

3. If leak is at hose/regulator connection:

This part is defective and you should contact the

customer service department for replacement.

If NO bubbles appear at any connection, the connections are secure.

NOTE: Whenever gas connections are loosened or removed, you must perform a complete leak test.

WARNING

Perform all leak tests outdoors.

• Extinguish all open flames.

• NEVER leak test when smoking.

• Do not use the heater until all connections

have been leak tested and do not leak.

Regulator / Cylinder

connection