Garden Treasures Living PG171H-B Manuel - Sayfa 17

Veranda Isıtıcı Garden Treasures Living PG171H-B için çevrimiçi göz atın veya pdf Manuel indirin. Garden Treasures Living PG171H-B 18 sayfaları. Gas patio heater

Sayfayı Yazdır

TROUBLESHOOTING

PROBLEM

Burner doesn't light

Burner flame is low

Carbon buildup

Thick black smoke

WARRANTY

The appliance has been manufactured under the highest standards of quality and workmanship. We

warrant to the original consumer/purchaser that all aspects of this product will be free of defects in

material and workmanship for one (1) year from the date of purchase. Replacements for any

defective part will be supplied free of charge for installation by the consumer. Defects or damage

caused by the use of other than genuine parts are not covered by this warranty. This warranty shall

be effective from the date of purchase as shown in the purchaser's receipt. This warranty is valid for

the original consumer purchaser only and excludes industrial, commercial or business use of the

product, product damage due to shipment or failure which results from alteration, product abuse or

product misuse, where performed by a container, service company or consumer. We will not be

responsible for labor charges and/or damage incurred in installation, repair or replacement, nor for

incidental or consequential damage. This warranty gives you specific legal rights, and you may also

have the other rights that vary from state to state.

POSSIBLE CAUSE

1. Gas pressure is low.

2. The orifice is blocked.

3. Control knob is not in "ON"

position.

1. Gas pressure is low.

2. The control knob is not

positioned at "High".

3. The burner jet is partially

blocked.

4. Outdoor temperature is less

than 40°F and tank is less

than 1/4 full.

5. Supply hose is bent or kinked.

Seasonal accumulation.

Blockage in burner

CORRECTIVE ACTION

1. Turn the gas cylinder valve "OFF"

and replace the cylinder.

2. Clear blockage.

3. Turn control knob to "ON"

1. Turn the gas cylinder valve "OFF"

and replace the cylinder.

2. Position the control knob at "High"

3. Clear blockage.

4. Use a full gas cylinder.

5. Straighten the hose.

Wipe off before lighting.

Remove blockage and clean burner

inside and outside.