Gardena 34 E basicMove Kullanım Talimatları Kılavuzu - Sayfa 4
Çim Biçme Makinesi Gardena 34 E basicMove için çevrimiçi göz atın veya pdf Kullanım Talimatları Kılavuzu indirin. Gardena 34 E basicMove 12 sayfaları. Electric flexible steerable lawnmower
Ayrıca Gardena 34 E basicMove için: Kullanım Talimatları Kılavuzu (13 sayfalar)
Sayfayı Yazdır
Only use permitted extension cables.
Ask your electrician.
Keep the extension cable away from the area
you are cutting.
The mains voltage and the equipment voltage
stated on the type plate must be the same. If
extension cables are used, these must comply
with the minimum cross-sections in the table
below :
Voltage
220 - 240V/ 50 Hz
220 - 240V/ 50 Hz
3. Assembly
Fitting the wheels :
4
Fit the upright :
9
B
D
C
A
5
Cable
Cross-
length
section
Up to 20 m
1.5 mm
20 - 50 m
2.5 mm
All 4 wheels must always be screwed in at the same cutting
height (see 4 Operation "Setting the cutting height" ).
1. Insert screw
the 6-sided head fully into the hub cap
Use wheel hub with short bolt for the front wheel and
2
1
3
wheel hub with long bolt for the rear wheel.
2. Press covering cap
place.
3. Insert screw
firmly in place by hand at the side and ensure it is securely
located. Screw in the small wheels (13 cm diameter) at the
front and the large wheels (16 cm diameter) at the rear.
The upper part of the upright is preassembled on the 34 E
basicMove lawnmower.
1. Insert long bolt
the upright holder
0
2. Screw lower part of upright
8
nut
. During this process, the wing nut
opposite side to the cable
6
3. Push upper part of upright
lower part of the upright
and lower part
8
Check positioning of the plug switch
along the side of the upright and must not cross over itself.
4. Push short bolt with cable guide
outside through the bore
5. Push short bolt without cable guide
7
the bore in the upper part of the upright
6. Place both wing nuts
7. Press cable
fasten to the lower part of the upright
A brief voltage dip may occur when you switch
on your electric lawnmower (due to conditions
of the power supply) that may affect other
devices (e.g. a lamp may flicker).
This problem should not occur with supply
impedances of Z
2
2
1
through the bore in the hub cap
3
into the hub cap
1
through the wheel
5
through the lower part of the upright
7
from the cable side.
6
9
.
0
into the grooves in the side of the
6
until the bores in the upper part
6
of the upright match precisely.
0
in the upper part of the upright
8
on the bolts
9
into the short bolt with cable guide
< 0,46 Ohm.
max
2
and push
2
.
2
until it snaps in
4
and screw the wheel
firmly in position with the wing
8
must be on the
D
9
. The cable
must run
A
on the cable side from
B
from outside through
0
.
A
B
/
and tighten firmly.
A
6
with the cable clip
4
6
and
0
0
.
and
C
.
13