Gardena 380 AC 4026 Kullanım Talimatları Kılavuzu - Sayfa 6
Çim Biçme Makinesi Gardena 380 AC 4026 için çevrimiçi göz atın veya pdf Kullanım Talimatları Kılavuzu indirin. Gardena 380 AC 4026 13 sayfaları. Accu rechargeable cylinder lawnmower
Sayfayı Yazdır
Switching off the cylinder
mower :
Adjusting the cutting height:
K
K
Mowing with the grass
collection sack (accessories) :
6. Putting into Storage
Storage :
16
Circuit Breaker : If the Cordless Motor Mower is overloaded
over a longer period of time the motor may become hot (Red
Error-LED flashes).To protect the motor from overheating the
circuit breaker switches the motor off. You can switch the mower
on again after approximately 5 -10 minutes.
Discharge protection :
The mower switches off automatically as soon as the capacity
of the Accu has been exhausted (discharge protection).
We recommend recharging the battery straight away.
Note : The accu cylinder mower can be operated with the Accu
or without as a hand mower.
The key prevents the cylinder mower being switched on
accidentally.
1. Release starting handle
2. Remove the safety key each time you stop work.
DANGER ! Cutting tool can cause injuries !
A
V When adjusting the cutting height, remove the key
The cutting height can be set to any
position between 12 mm and 42 mm.
1. Stand behind the cylinder mower
with one foot on the roller
2. Slacken the two locking screws
and set to the height required on
the scale
3. Tighten the two locking screws
on both sides to the same height.
The locking screws
J
both sides.
The mower may only be adjusted to a depth in which the lower
blade does not touch the ground when it is uneven.
v Suspend the grass collection sack in the cylinder mower
as described in the Operating Instructions.
1. Remove safety key.
2. Charge Accu (see 7. Maintenance).
3. Clean mower before storage and connect to the charger
(see 7. Maintenance).
4. Store mower in a dry, frostproof but cool place out of reach of
children.
To save space, the cylinder mower can be folded up by folding
the clamping lever. Ensure the cable is not trapped during this
process.
I
.
and wear suitable work gloves.
J
.
L
.
K
must always be set to the same height on
K
K
L