Gardena 5041 Operatör El Kitabı - Sayfa 5
Çim Biçme Makinesi Gardena 5041 için çevrimiçi göz atın veya pdf Operatör El Kitabı indirin. Gardena 5041 10 sayfaları. Battery lawnmower
Ayrıca Gardena 5041 için: Operatör El Kitabı (17 sayfalar), Operatör El Kitabı (17 sayfalar)
Sayfayı Yazdır
Additional safety warnings
Battery safety
DANGER! Fire risk!
The battery to be charged must be placed on a nonflammable, heat
resistant and non-conductive surface while charging.
The supply terminals are not to be short-circuited.
Keep corrosive, flammable and easily combustible objects clear of
the battery charger and the battery.
Do not cover the battery charger and the battery while charging.
Disconnect the battery charger immediately in the event of smoke formation or fire.
Only use the original GARDENA Charger to charge the battery. The use of other
battery chargers may damage the batteries irreparably and even cause a fire.
Only use original GARDENA batteries for the GARDENA battery product.
Do not charge any third-party batteries. There is a risk of fire and explosion!
If you notice fire: Extinguish the flames with oxygen reducing materials.
DANGER! Risk of explosion!
Protect batteries from heat and fire. Do not leave on radiators or expose
to strong sunshine for long periods.
Do not operate in explosive atmospheres, such as in the presence of
flammable liquids, gases, or dust. Batteries may create sparks which
could ignite the dust or fumes.
Check your replacement battery before each use. Visually check the battery
before each use. A non-functioning battery must be disposed of correctly. Do not
send by post. For further details, please contact your local disposal companies.
For risks of injury do not use the battery as a power source for other products.
Only use the battery for the GARDENA product intended.
Only charge and use the battery in ambient temperatures of between 0 °C and
40 °C. Allow battery to cool down after long periods of use.
Check the charging cable regularly for signs of damage or ageing (brittleness).
Only use it in perfect condition.
Do not stow or transport the battery above 45 °C or in direct sunlight. Ideally,
the battery should be stored below 25 °C so that self-discharge is low.
Do not expose the battery to rain or wet conditions. Water entering a battery will
increase the risk of electric shock.
Keep battery in order (clean) especially air vents.
If usage of the battery is not planned for a certain time (winter period) reload the
battery to avoid a deep discharge.
Do not store while still attached to a tool, this prevents misuse and accidents.
Do not store the battery in places where static electricity is present.
Electrical safety
DANGER! Cardiac arrest!
This product makes an electromagnetic field while it operates. This field
may under some conditions interfere with active or passive medical
implants. To decrease the risk of conditions that can possibly injure or
kill, we recommend persons with medical implants to speak with their
physician and the medical implant manufacturer before you operate the
product.
Before use, examine the cable for signs of damage or ageing. If the cable is
found to be defective, take the product to an Authorised Service Centre and
have the cable replaced.
Do not use the product if the electric cables are damaged or worn.
Immediately disconnect from the mains if the charger cable is cut, or the insula-
tion is damaged. Do not touch the electric cable until the cable has been discon-
nected. Do not repair a cut or damaged cable. Replace it with a new one.
Do not carry the product by the cable.
Do not pull on the cable to disconnect any of the plugs.
Use only on AC mains supply voltage shown on the product rating label.
Our products are double insulated to EN 60335. Do not connect an earth to
any part of the product.
Check the working area for hidden cables.
Do not use for pond care or close to water.
Personal safety
DANGER! Risk of suffocation!
Small parts can be easily swallowed. There is also a risk that the poly-
bag can suffocate toddlers. Keep toddlers away when you assemble the
product.
Do not use in explosive atmosphere.
Never operate the product when you are tired, ill or under the influence of alcohol,
drugs or medicine.
Do not overload the mower.
Use gloves, wear slip resistant shoes and wear eye protection.
Do not use under wet conditions.
10
Do not disassemble the product further than the delivery status.
Only start the mower with an upright standed handle.
Do not use the start levers alternately.
Use the handles carefully.
Safety Cut-Out
The engine is protected by a Safety Cut-Out which is activated when the blade
becomes jammed or if the engine is overloaded. When this occurs, stop and dis-
connect the product from the mains. The Safety Cut-Out will only reset when you
release the start/stop lever. Clear any obstruction and wait for a few minutes for
the Safety Cut-Out to reset before you continue to use the product.
2. ASSEMBLY
DANGER! Risk of injury!
Cut injury when the blade turns or the product starts
accidentally.
v Wait for the blade to stop, remove the safety key and use
gloves before you do assembly.
To connect the lower handle [ Fig. A1 / A2 ]:
The handle height can be adjusted in 3 positions:
–
(h)
high
–
(m)
middle
–
(l)
low
(1)
1. Turn the lower handle
that the handle hole is inline with the hole
(m)
or
(l)
of the height adjusting.
2. Push the screws
(2)
through the holes.
3. Put the wing nuts
(3)
on the screws
(3)
4. Tighten the wing nuts
.
To connect the upper handle [ Fig. A3 ]:
1. Put the upper handle
(4)
on the lower handle
Make sure that the handles are fully in place and the handle
holes are inline.
(2)
2. Push the screws
through the holes.
(P)
3. Put the plastic washers
and the wing nuts
(3)
4. Tighten the wing nuts
.
To fix the cable to the handle [ Fig. A4 ]:
1. Fix the cable
(5)
to the handle with the clip
(5)
2. Check that the cable
is not trapped between the lower and
the upper handle.
3. OPERATION
DANGER! Risk of injury!
Cut injury when the blade turns or the product starts
accidentally.
v Wait for the blade to stop, remove the safety key and use
gloves before you attach the battery or transport the product.
To charge the battery [ Fig. O1 ]:
CAUTION!
Overvoltage damages the battery and the battery charger.
v Make sure that you use the correct mains voltage.
Before you use the battery the first time, the battery must be completely
charged.
The lithium-ion battery can be charged in any state of charge and the
charging process can be disconnected at any time without to damage
the battery (no memory effect).
1. Connect the mains cable
(M)
to the charger
2. Connect the mains cable
(M)
to a 230 V mains socket.
3. Connect the battery charger cable
When the charging control lamp
once per second the battery is being charged.
(2)
.
(1)
.
(3)
(2)
on the screws
.
(6)
.
(C)
.
(E)
to the battery
(B)
.
(Lc)
at the charger flashes green
(h)
,