KitchenAid KESC300BWH1 Kurulum Talimatları Kılavuzu - Sayfa 5

Fırın KitchenAid KESC300BWH1 için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. KitchenAid KESC300BWH1 7 sayfaları. 30" (76.2 cm) electric slide-in range with self-cleaning thermal/convection oven
Ayrıca KitchenAid KESC300BWH1 için: Kullanım ve Bakım Kılavuzu (5 sayfalar)

Sayfayı Yazdır

Using the 3/8" (0,95 cm) brass nuts, attach

the neutral (white) of power supply cable to the

silver-colored center screw of the terminal

block. Place the hook-shaped end of the wire

over the terminal block screw with open side of

the hook facing to the right. Squeeze hook end

of wire together to form a loop.

Connect the other two wires to the outer

terminal block screws. Attach wires using the

same method as the neutral wire (See Figure

23.)

Do Not loosen the factory-installed

nuts on the

terminal block.

Center wire MUST be connected to center

screw.

Tighten conduit connector, locking ring and

clamping screws.

Reattach terminal block cover.

Now start...

With range in kitchen.

I_I

emove shipping materials, tape and

protective film from range. Keep

cardboard bottom and shipping base under

range. Remove oven racks and parts package

from inside oven.

Take 4

cardboard

corners from

the carton. Stack one

cardboard corner on

top of another.

Repeat with the other

two corners. Place

corners lengthwise on

the floor in back of

range so corners will

support outer side

edges of range as

shown.

spacers

; cardboard

corners

Personal Injury Hazard

Because of the weight and size of the

range, two or more people are needed to

move and safely install it.

Failure to do so could result in personal

injury.

Flr , ° re, no eno, n e,r

zit

ull cardboard bottom and shipping base

firmly to remove.

Use an adjustable wrench to

loosen the leveling legs 1-1/2 turns.

Piece cardboard or hardboard in front of

range. Stand range back up onto

cardboard or hardboard.

Personal Injury Hazard

• To reduce the dsk of tipping of the

appliance, the appliance must be secured

by a properly installed floor-mounted anti-tip

bracket supplied with the range.

• Save these Installation Instructions. If range

is moved to a new location,

the anti-tip

bracket must be removed and reinstalled in

the new location.

Electrical Shock Hazard

• Take special care when ddlling holes into

the floor. Electrical wires or plumbing may

be located beneath floor.

• Locate the electrical circuits that could be

affected by the installation of this bracket

and turn off power to these circuits.

Failure to follow these instructions may result

in electrical shock or other personal injury.

5.13

Numbers

correspond

to steps.

12. 15.

Panel D