Gardena 10500 Operatör El Kitabı - Sayfa 6
Su Pompası Gardena 10500 için çevrimiçi göz atın veya pdf Operatör El Kitabı indirin. Gardena 10500 14 sayfaları. Clear/dirty water submersible pump
Sayfayı Yazdır
4. MAINTENANCE
DANGER! Risk of injury!
Injury when the product starts accidentally.
v Disconnect the product from the mains before
you maintain the product.
5. STORAGE
To put into storage:
The pump is not frost-proof!
The product must be stored away from children.
1. Disconnect the pump from the mains.
2. Turn the pump upside down until no more water runs
out.
3. Clean the pump (see 4. MAINTENANCE).
4. Store the pump in a dry, enclosed and frost-free place.
6. TROUBLESHOOTING
DANGER! Risk of injury!
Injury when the product starts accidentally.
v Disconnect the product from the mains before
you troubleshoot the product.
To clean the suction base and the impeller [ Fig. T1 ]:
1. Unscrew the 4 Phillips screws
Problem
Pump is running, but
doesn't deliver water
Pump does not start, or stops
suddenly during operation
14
(4)
.
Possible Cause
Air cannot escape, because the
pressure line is closed. (Pos sible kink
in the pressure hose.)
Air in suction foot.
Suction opening is clogged.
Hose is clogged.
Impeller is blocked.
Water level below minimum water
level when put into operation.
Thermal switch has turned the pump
off because of overheating.
No power supply to the pump.
RCD has triggered
(residual current).
To flush the pump:
After pumping chlorinated water, the pump must be
flushed.
1. Pump lukewarm water (max. 35 °C), possibly adding
a mild cleaning agent (e. g. detergent) until the pumped
water runs clear.
2. Remove residuals according to the waste disposal laws
applicable in your area.
Disposal:
(in accordance with RL2012/19/EC)
The product must not be disposed of to normal
household waste. It must be disposed of in line
with local environmental regulations.
IMPORTANT!
v Dispose of the product through or via your municipal
recycling collection centre.
(5)
2. Pull the suction base
(5)
3. Clean suction base
and impeller
does not become void as a result of this maintenance
work).
4. Reinstall the suction base
5. Screw in the 4 Phillips screws
For safety reasons a damaged impeller can only be
exchanged by the GARDENA Service Centre.
Remedy
v Open the pressure line (e. g. shut-off
valve, delivery units).
v Wait for about 60 seconds until
the pump has vented; if necessary,
turn off and then on again.
v Clean the suction opening with
a water jet.
v Remove the clog from the hose.
v Clean the impeller.
v Submerge the pump deeper.
v Clean the suction opening. Observe
the max. media temperature (35 °C).
v Check fuses and electrical plug
connections.
v Disconnect the pump and contact
the GARDENA Service.
off the pump.
(6)
(the warranty
(5)
.
(4)
again.