Gardena 11000 SL automatic Kullanım Talimatları Kılavuzu - Sayfa 7

Su Pompası Gardena 11000 SL automatic için çevrimiçi göz atın veya pdf Kullanım Talimatları Kılavuzu indirin. Gardena 11000 SL automatic 10 sayfaları. Submersible pump

Sayfayı Yazdır

6. Trouble-Shooting

Problem

Pump is running,

but doesn't deliver.

Pump doesn't start or

suddenly stops during

Pump runs, but output

suddenly decreases.

Pump does not reach

residual water height of 1 mm

during flat suction.

Pump does not switch on or

off automatically when set

to automatic operation.

Attention !

If you have any problems with your Pump, please contact our Service.

7. Storage

Frost-free storage

Disposal :

(in accordance with

RL 2002 / 96 / EC)

Probable cause

Air cannot escape, since

pressure line is closed.

Air locks in the suction base.

Impeller clogged.

When starting the pump,

water height falls below the

min. water level.

Thermal overload switch has

switched the pump off due

to overheating.

No power.

Dirt particles are jammed

in the suction base.

Suction base is clogged.

The suction base cover

missing in the suction base.

The pump is not upright.

The integral float switch

is sticking.

Repairs on electrical parts should only be done by our

GARDENA Service Centres.

Store the pump away from frost before the first frost sets in.

The device must not be added to the normal household waste,

it must be disposed of in accordance with local regulations.

Remedy

v Open pressure line

(e.g. kinked pressure pipe).

v Wait for max. 3 minutes

until the pump deaerates

automatically over the vent

valve. If necessary, switch

off and start it again.

v Disconnect plug and clean

impeller (see 5. Cleaning).

v Fill the pump over the

universal fitting

water.

v Disconnect plug and clean

impeller (see 5. Cleaning).

Observe max. media temper-

ature of 35 °C.

v Check fuses and electric

connections.

v Disconnect plug and clean

suction base (see 5. Clean-

ing).

v Disconnect plug and clean

suction base (see 5. Clean-

ing).

v Disconnect plug and install

the suction base cover

(see 5. Cleaning).

v Place pump in an upright

position.

v Clean float switch (see

5. Cleaning).

with