Gardena 5000 S Kullanım Talimatları Kılavuzu - Sayfa 2

Su Pompası Gardena 5000 S için çevrimiçi göz atın veya pdf Kullanım Talimatları Kılavuzu indirin. Gardena 5000 S 6 sayfaları. Submersible pump

Sayfayı Yazdır

Gardena 5000 S Kullanım Talimatları Kılavuzu

GARDENA Submersible Pump 5000 S

Welcome to the garden of GARDENA ...

Please read these operating instructions carefully and observe

the notes given. Use the instructions to familiarise yourself with

the submersible pump, its correct use, and the notes on safety.

For safety reasons, children under 16 as well as persons not

familiar with these operating instructions should not use this

submersible pump.

v Keep these operating instructions in a safe place.

Contents

1. Applications Range of Your GARDENA Submersible Pump

2. For Your Safety

3. Initial Operation

4. Operation

5. Cleaning

6. Trouble-Shooting

7. Storage

8. Technical Data

9. Service

1. Applications Range of Your GARDENA Submersible Pump

GARDENA Submersible Pumps have been designed for private

Intended use

use around your house and garden. They are predominantly desti-

nated for drainage after flooding, transfer of liquids, draining con-

tainers, taking water from wells and shafts, draining boats and

yachts as well as for water aeration and circulation for a limited

period of time.

Liquids which can be handled by the GARDENA Submersible

Liquids to be pumped

Pump are the following: clean and slightly contaminated water

(max. particle size 5 mm), swimming pool water (prerequisite

is the recommended dosage of additives) and soapy water.

The pump is fully submersible (waterproof sealed) and can be

immersed in the liquid down to a depth of 9 m.

The GARDENA Submersible Pumps are not designed for

Please note

continuous operation (e.g. continuous circulating opera-

tion) in a pond. Your pump's life will be shortened corre-

spondingly by such operation.

Corrosive, easily combustible or explosive substances

(e.g. gasoline, petroleum, nitro thinner), fats, oils, salt-water

and waste water of toilets and urinals must not be pumped.

The temperature of the liquid handled should not exceed

35 °C.

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

2. For Your Safety

Residual-current device

In Austria

. .

In Switzerland

Mains power

Visual check

Manual operation

Notes on use

According to DIN VDE (German Electrical Engineers' Associa-

tion) 0100, submersible pumps may only be used in swimming

pools, garden ponds, and fountains if the pump is operated via a

residual-current device with a residual-current rating of ≤ 30 mA.

The pump must not be operated

when there are persons in the swimming pool or garden pond.

For safety reasons we recommend that you always operate

the submersible pump via a residual-current device (DIN VDE

0100-702 and 0100-738).

v Please contact your electrician.

In Austria, according to ÖVE B / EN 60 555 part 1 to 3, pumps

which are used in swimming pools and garden ponds, and

equipped with firm power cable should be fed via an ÖVE

approved isolating transformer – rated voltage must not exceed

230 V.

In Switzerland mobile appliances which are used outdoors,

must be connected via a residual-current device.

According to DIN VDE (German Electrical Engineers' Associa-

tion) 0620, mains power cables must not have a smaller cross-

section than the rubber-sheathed cables of the designation

H05 RNF. The cable length must be at least 10 m.

Data indicated on the type plate must match technical data of

the mains supply.

v Take care that the electrical connections are made within dry

area, protected from flooding.

Protect plug and power cable from heat, oil and sharp edges.

v Don't use the power cable for plugging off.

The power cable or the float switch must not be used for mount-

ing or relocating the pump. For submerging or lifting / securing

the pump, fix a rope to the pump's carrying handle.

Extension cables must meet the requirements of DIN VDE 0620.

v Before operating the pump, first make a visual check, if there

is any damage of the pump (esp. regarding power cable and

plug).

v Observe the minimum water level and the max. delivery

height (see 8. Technical Data).

A damaged pump must not be used.

v In case of damage, please have the pump checked by our

GARDENA Service Centre.

During manual operation, the pump must be switched off as

soon as all the liquid has been pumped away.

v Observe the pump at all times during manual operation.

v Clear the outlet line before use.

Dry-running operation causes increased wear and is to be

avoided. Therefore, in manual operation the pump must be

immediately unplugged when water fails to flow.