Gardena 6000 1777 Çalıştırma Talimatları Kılavuzu - Sayfa 7
Su Pompası Gardena 6000 1777 için çevrimiçi göz atın veya pdf Çalıştırma Talimatları Kılavuzu indirin. Gardena 6000 1777 14 sayfaları. Submersible pump/dirty water pump
Sayfayı Yazdır
0
q
8
ß
S
9
7
7. Troubleshooting
Problem
Pump is running,
but does not deliver
Pump doesn't start or
suddenly stops during
operation
Pump runs, but output
suddenly decreases
For any other malfunctions please contact the GARDENA service department.
Repairs must only be carried out by GARDENA service departments or specialist
dealers authorised by GARDENA.
1. Unscrew the cross-head screws
base
8
from the pump.
ß
2. Press snap hooks
S
suction foot
8
and clean.
8
3. Clean suction foot
8
4. Refit suction foot
and screw in the cross-head screws
During this, ensure that the sealing ring
5. Reinsert the safety cover
For safety reasons a damaged feed impeller
exchanged by the GARDENA Service Centre.
WARNING! Electric shock!
Risk of injury due to electric shock.
v Disconnect the pump from the mains before
rectifying faults.
Possible Cause
Air cannot escape as pressure
line is closed
(e. g. kinked pressure pipe).
Air locks in the suction base.
Feed impeller clogged.
When starting the pump,
water height falls below the
minimum water level.
Thermal overload switch has
switched the pump off due to
overheating.
No power.
Dirt particles are jammed in
the suction base.
Suction base is clogged.
9
and remove the suction
together and remove safety cover
0
and impeller
.
q
is seated correctly.
7
in the suction foot
Remedy
v Open pressure line.
v Wait for max. 60 seconds
until the pump deaerates
automatically over the vent
valve. If necessary, switch
off and start it again.
v Disconnect plug and
clean feed impeller
(see 6. Cleaning).
v Submerge pump deeper
into water.
v Disconnect plug and
clean feed impeller
(see 6. Cleaning).
Observe maximum water
temperature of 35 °C.
v Check fuse and electrical plug
and socket connections.
v Disconnect plug and clean
suction base (see 6. Cleaning).
v Disconnect plug and clean
suction base (see 6. Cleaning).
7
from
9
again.
8
again.
0
can only be
15