Gardena 6000/5 inox automatic Kullanım Talimatları Kılavuzu - Sayfa 6

Su Pompası Gardena 6000/5 inox automatic için çevrimiçi göz atın veya pdf Kullanım Talimatları Kılavuzu indirin. Gardena 6000/5 inox automatic 17 sayfaları. Deep well pump
Ayrıca Gardena 6000/5 inox automatic için: Kullanım Talimatları Kılavuzu (9 sayfalar), Kullanım Talimatları Kılavuzu (9 sayfalar), Kullanım Talimatları Kılavuzu (9 sayfalar), Operatör El Kitabı (9 sayfalar), Kullanım Talimatları Kılavuzu (9 sayfalar), Kullanım Talimatları Kılavuzu (10 sayfalar)

Sayfayı Yazdır

Gardena 6000/5 inox automatic Kullanım Talimatları Kılavuzu

Connect hose to output side:

6 b

5. Operation

Electronic Pressure Pump

turn on:

Priming cycle

The hose can be connected either to the delivery side 33.3 mm

(G 1)-thread of the 120° swivelling connection k and/or of the

horizontal connection

1. Seal the connection not required with the sealing cap

provided.

2. Connect delivery hose

TIP:

Use pressure-tight hoses, such as e.g. the GARDENA Profi Plus

hose with 19 mm (3/4") diameter, art. no. 4432 / 8452, in conjunction

with the GARDENA fast connection threaded connector with a

33.3 mm (G1) internal thread art. no. 7109 and the GARDENA

suction and high pressure connector, art. no. 7120, for 19 mm

(3/4") hoses and a GARDENA hose clamp art. no. 7192.

Never use suction hoses.

Danger ! Electric shock !

Risk of injury due to electric shock.

➔ Unplug the pump from the mains before filling.

Warning ! Pump running dry.

➔ Fill the pump to the overflow (approx. 2 to

1. Unscrew the cover

2. Turn rotary switch

The integrated non-return valve will open.

3. Open any shut-off devices in the delivery line (watering

accessories, water stop, etc.) so that air can escape before the

priming procedure begins.

4. Empty any water remaining in the delivery hose so that the air

can escape during filling and priming.

5. Fill slowly with water via the filler connection

overflows (approx. 2 to 3 l).

6. Close cover

The maximum self-priming head of 9 m (art. 1769 8 m) is only

achieved if the pump is filled until it overflows via the filler connection

and the delivery hose is held high enough so that no water can

escape via the delivery hose. It is not necessary to hold up the

delivery hose if filled suction hoses with backflow preventer are

used.

7. Insert mains plug into a 240 V / 50 Hz AC socket.

Warning! The pump will start immediately!

During the priming cycle (01) the pump will try to draw in

water for 4 minutes.

to the delivery side connection.

3 litres) with the water each time before the

pump is switched on.

of the filter chamber by hand.

to START.

of the filter chamber by hand again.

until it