Corvette BLU-C5 Kurulum Kılavuzu - Sayfa 3

Otomobil Aksesuarları Corvette BLU-C5 için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Corvette BLU-C5 11 sayfaları. Streaming module for 1997-04 corvette
Ayrıca Corvette BLU-C5 için: Hızlı Başlangıç Kurulum Kılavuzu (9 sayfalar)

Sayfayı Yazdır

Installation 2:

Installing module to 10-pin CD plug in trunk/hatch using

the PXHGM2 installation harness. CD changer (if present) must be

disconnected.

Purchase module with PXHGM2 harness if vehicle has 10-

pin CD plug in trunk/hatch (See Fig. 3). The BLU-C5 will

turn on/off with ignition key.

the 10-pin plug requires routing getting power wire

(See. Fig. 6) from fuse panel in passenger foot well

Locate factory 10-pin CD plug in trunk or hatch area (See Fig.3) or if

vehicle has a CD changer, disconnect 10-pin plug from 12-disc CD changer

(See Fig. 4),

2. Mate factory 10-pin CD plug (See Fig. 3) to installation harness 10-pin

socket (white) (See Fig. 5)

12-disc changer

Connecting the BLU-C5 to

Fig. 3

10-pin CD plug

Fig. 4

3. Route power wire (See Fig. 6) to 12V accessory supply in vehicle.

(This step is required because there are no accessory (switched) supply

wires on 10-pin CD changer plug.

Accessory wire

Where to get 12V Accessory (Switched power):

1997-03 vehicles include a 3-pin plug under passenger toe board near BCM

(may be covered in black duct tape) -- See Fig. 7

The yellow wire is ACC (Switched).

Alternate 12V Acc. supply on page 4

Fig. 5

10-pin socket

Fig. 6

If vehicle does not have 3-pin plug; see