•
Load paper, transparencies, and card stock with the
recommended print side faceup and the top edge entering
the printer first. For more information on loading
transparencies, see the packaging the transparencies came
in.
•
Load letterhead with the logo faceup and the top edge
entering the printer first.
•
Load envelopes with the flap side down and the stamp
location in the position shown. The stamp and address are
shown to illustrate the proper orientation for loading
envelopes.
Warning—Potential Damage: Never use envelopes
with stamps, clasps, snaps, windows, coated linings, or
self-stick adhesives. These envelopes may severely
damage the printer.
4
Squeeze the tab located on the right width guide to adjust the
guides to lightly touch the sides of the stack.
5
5
Slide the paper gently into the multipurpose feeder until it
comes to a stop. Paper should lie flat in the multipurpose
feeder. Make sure the paper fits loosely in the multipurpose
feeder and is not bent or wrinkled.
6
From the printer control panel, set the Paper Size and Paper
Type.
Setting the Paper Size and
Paper Type
After you set the Paper Size and Paper Type to the correct settings
for the size and type used in the trays, then any trays containing
the same size and type are automatically linked by the printer.
Note: If the size of the paper being loaded now is the same size as
the previously loaded paper, do not change the Paper Size setting.
1
Make sure the printer is on and Ready appears.
2
From the printer control panel, press
Paper Menu appears.
3
Press
.
4
Press the arrow buttons until Size/Type appears, and then
press
.
Select Source appears.
5
Press the arrow buttons until the correct source appears, and
then press
.
Size appears under the source name.
6
Press
.
.
Sayfayı Yazdır