Gardena HS 36 Kullanım Talimatları Kılavuzu - Sayfa 8
Düzeltici Gardena HS 36 için çevrimiçi göz atın veya pdf Kullanım Talimatları Kılavuzu indirin. Gardena HS 36 12 sayfaları. Accu hedge trimmer
Ayrıca Gardena HS 36 için: Kullanım Talimatları Kılavuzu (9 sayfalar)
Sayfayı Yazdır
Problem
Lawn cut unevenly
Adjusting the cutting
mechanism :
L
Repairs :
Possible cause
Blade set incorrectly.
Cutting mechanism blunt.
Lawn too long / too wet.
The cutting gear of your lawn mower was optimally adjusted be-
fore leaving our company. If, after longer use, a clean cut of the
grass is no longer possible or the blade roller contacts the lower
blade, then the lower blade should be adjusted.
1. Remove the plug from the mains socket.
2. Check cylinder
these with a grindstone if necessary.
J
3. Unscrew internal hexagon screws
wrench (5 mm) anticlockwise until the cylinder
4. Push the feeler gauge supplied (thin strip of metal)
M
left side between one blade
K
blade
.
5. Tighten left internal hexagon screw
K
hexagon wrench (5 mm) until the feeler gauge
gently.
6. Continue turning the cylinder until the blade
adjusted on the left side, is exactly above the lower blade
on the right side.
7. Tighten the right internal hexagon screw
hexagon wrench (5 mm) until the feeler gauge
gently.
8. Rotate cylinder
open up the internal hexagon screw
affected.
When the cylinder and the lower blade can hardly be heard
touching each other, the cutting mechanism has been adjusted
correctly.
J
9. Cutting test:
Place a strip of paper
N
that it points towards the spindle of the cylinder
10. Turn cylinder
If the lower blade is set correctly
K
as if with scissors.
11. Repeat the cutting test on the other blades
On safety grounds, only original GARDENA spares
A
may be used.
Please contact GARDENA Service if it is necessary to replace
the cutting tool, which will only become blunt after several years
use if well-maintained.
Remedy
v Adjust cutting mechanism.
Recommendation:
v Have cutting mechanism
reground or replaced by
GARDENA Service.
v See 4. Function "Mowing
Tips".
J
K
and lower blade
L
J
on the cylinder and the lower
L
J
. If a banging noise is produced during this,
N
in such a way on the lower blade
J
carefully.
K
for notches and remove
with an internal hexagon
J
turns freely.
M
on the
with an internal
M
is held
J
, already
K
L
with an internal
M
is held
L
slightly on the side
J
.
the paper will be cut off
J
.
K
17