Gardena 1806 Çalıştırma Talimatları - Sayfa 11

Çim ve Bahçe Ekipmanları Gardena 1806 için çevrimiçi göz atın veya pdf Çalıştırma Talimatları indirin. Gardena 1806 20 sayfaları.

10. Changing the Setting

The time and the watering time can be changed using the control knob

(Run Time).

The changes are accepted after approx. 5 seconds and this is signalled

acoustically by a double beep. If the water timer is not reset the original

starting time remains unchanged.

You can change the watering time (Run Time) during an automatic water-

ing program as follows:

.If the elapsed watering time is shorter than the new watering time you

have selected, then the new watering time is valid.

Example :

Old Run Time = 10 minutes, changed after 5 minutes to 30 minutes.

The total watering time is then 30 minutes.

.If the watering time which has already expired is longer than the new

watering time, the water flow is interrupted in the next minute.

If you have already chosen the starting time (Start Time / Run Time

already set) any changes you make to the watering frequency (Frequency)

are active as soon as the next watering program starts.

If you have forgotten the current start time, you should reset the Water

Timer and then re-enter the watering data.

11. Battery

11.1 Status indicator

If the battery capacity falls below a certain level, a warning signal sounds

every 15 seconds. The programs you have set are not run. The water flow

cannot be opened manually. If a valve is open, however, it will be closed.

If the battery capacity is too low (the warning signal beeps every

15 seconds), you must change the battery. To do this, the water timer

must be removed from the tap.

Important : Changing the battery deletes the data you have set.