Makita XST01Z Kullanım Kılavuzu - Sayfa 7
Elektrikli Alet Makita XST01Z için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Makita XST01Z 10 sayfaları. Cordless oil-pulse driver
Sayfayı Yazdır
Impact force grade
displayed on panel
Hard
Medium
Soft
T mode
015148
The impact force can be changed in four steps: hard,
medium, soft, and T mode.
This allows a tightening suitable to the work.
Every time the button
changes in four steps.
For approximately one minute after releasing the switch
trigger, the impact force can be changed.
"T" is a special mode for fastening self drilling screws
and bolts. In this mode, the tool starts to drive a screw
with faster rotation, which is suited for drilling with the
self-drilling -screw tip. Once the tool starts to tighten the
screw, it impacts in soft force grade.
NOTE:
When all lamps on the switch panel go out, the tool
•
is turned off to save the battery power. The impact
force grade can be checked by pulling the switch
trigger to the extent that the tool does not operate.
While pulling the switch trigger, the impact force
•
grade cannot be changed.
The tool automatically stops to prevent the
•
damages on the parts during heavy load operation
with hard or medium impact force grade. In that
case select the soft or T mode impact force grade.
Maximum blows
2,700
(/min)
2,200
(/min)
1,400
(/min)
1,400
(/min)
is pressed, the number of blows
Application
Tightening when force
and speed are desired.
Tightening when a good
finishing is needed.
Tightening when excessive
tightening need to be avoided
because of potentially clogged
female screw and broken or
damaged screw head.
Tightening when speed
and good finishing are
needed.
7
Work
Tightening in underwork
material / Tightening long
screws.
Tightening in the finishing
board, plaster board.
Tightening sash screw/
Tightening small screws
such as M6.
Tightening bolt up to M8.
Tightening when speed
and good finishing are
needed.
Tightening bolt up to M8.