KitchenAid KHHC2090SBL 2.0 Kurulum Talimatları Kılavuzu - Sayfa 9

Mikrodalga Fırın KitchenAid KHHC2090SBL 2.0 için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. KitchenAid KHHC2090SBL 2.0 12 sayfaları. Installation instructions

Sayfayı Yazdır

1. Product Dimensions

5. Cut the 1 " (3.8 cm) diameter hole at the circular shaded area

"G" on the template. This hole is for the power supply cord.

NOTE: If upper cabinet is metal, the supply cord bushing needs to

be installed around the supply cord hole, as shown.

A. Metal cabinet

B. Power supply cord bushing

6. Drill 3/8" (10 mm) holes at points "D" and "E" on the template.

These are for two 1/4-20 x 3" flat-head bolts and washers

used to secure the microwave oven to the upper cabinet.

For Roof Venting Installation Only

7. Cut 3/4" (19 mm) hole at one corner of the shaded rectangular

area "F" on Upper Cabinet Template.

8. Using a keyhole saw, cut out the rectangular area.

Install the Microwave Oven

WARNING

Excessive Weight Hazard

Use two or more people to move and install

microwave oven.

Failure to do so can result in back or other injury.

IMPORTANT: The right side of the unit is the heavy side. Handle

the microwave oven gently.

1. Place a washer on each 1/4-20 x 3" flat-head bolt and place

inside upper cabinet near the 3/8" (10 mm) holes.

2. Make sure the microwave oven door is closed and taped shut.

3. Using 2 or more people, lift microwave oven and hang it on

support tabs at the bottom of mounting plate.

NOTE: To avoid damage to the microwave oven, do not grip or

use the door or door handle while the microwave oven is being

handled.

A. Mounting plate

B. Support tabs

4. With front of microwave oven still tilted, thread power supply

cord through the power supply cord hole in the bottom of the

upper cabinet.

5. Rotate microwave oven up toward upper cabinet.

NOTE: If venting through the wall, make sure the damper

assembly fits easily into the vent in the wall cutout.

6. Push microwave oven against mounting plate and hold in

place.

NOTE: If microwave oven does not need to be adjusted, skip

steps 7-9.

7. If adjustment is required, rotate microwave oven downward.

Using 2 or more people, lift microwave oven off of mounting

plate, and set aside on a protected surface.

8. Loosen mounting plate screws. Adjust mounting plate and

retighten screws.

9. Repeat steps 3-6.

10. With the microwave oven centered, and with at least one

person holding it in place, insert bolts through upper cabinet

into microwave oven. Tighten bolts until there is no gap

between upper cabinet and microwave oven.

NOTES:

Some upper cabinets may require bolts longer or shorter than

3" (7.6 cm). Longer or shorter bolts are available at most

hardware stores.

Overtightening bolts may warp the top of the microwave oven.

To avoid warping, wood filler blocks may be added. The

blocks must be the same thickness as the space between the

upper cabinet bottom and the microwave oven.

A. 1/4-20 x 3" flat-head bolts