Avaya B159 Series Yapılandırma Kılavuzu

Telefon Avaya B159 Series için çevrimiçi göz atın veya pdf Yapılandırma Kılavuzu indirin. Avaya B159 Series 2 sayfaları. Configuring b100 series phones on ip office
Ayrıca Avaya B159 Series için: Hızlı Referans Kılavuzu (4 sayfalar), Hızlı Referans Kılavuzu (4 sayfalar), Hızlı Kurulum Kılavuzu (4 sayfalar)

Sayfayı Yazdır

Introduction

The B100 Series of phones are a range of high-quality audio conference phones. The IP Office platform supports the

B149 (analog), B159 (analog) and B179 (SIP) models. The following are the key steps to enable correct operation on IP

Office systems:

1. Set the region

2. Set the flash hook time (B149/B159 phones only)

3. Set the caller ID method (B149/B159 phone only)

4. Set the conference codes

Full SIP phone installation of the B179 is covered in the "Installing and Administering the IP Office B179 SIP Conference

Phone" manual.

Set the Region

To set the region:

1. Press the

Menu button.

2. Scroll to SETTINGS and press OK.

3. Scroll to REGION and press OK.

4. Scroll to the region required and press OK.

5. To exit the menus, press

Set the Flash Hook Time

The B149 and B159 analog phones need to use a flash hook time in the same range as that being used by the IP Office.

That default values the IP Office uses depend on its system locale, refer to the "IP Office Locale Settings Reference"

manual. However, individual extensions can be configured separately (see Extension | Analogue | Flash Hook Pulse

Width). The setting can be tested by making a call to another extension during which pressing

on hold and back if the flash hook time is set correctly.

To set the flash hook time:

1. Press the

Menu button.

2. Scroll to SETTINGS and press OK.

3. Scroll to FLASH and press OK.

4. Select a value that falls in the range set in the IP Office configuration for the extension and press OK.

5. To exit the menus, press

Set the Caller ID Type

B149/B159 phones need to be set to use the same caller ID method as the IP Office system (System | Telephony |

Tones & Music | CLI Type).

To set the caller ID type:

1. Press the

Menu button.

2. Scroll to SETTINGS and press OK.

3. Scroll to CALLER ID and press OK.

4. Select the method that matches the IP Office system and press OK.

5. To exit the menus, press

Job Aids

IP Office

Configuring B100 Series

Phones on IP Office

Menu again. To exit the current menu option, press

should toggle the call

03a (22/09/2017)

Page 1