Gardena SmallCut 300 Kullanım Talimatları Kılavuzu - Sayfa 6
Çim ve Bahçe Ekipmanları Gardena SmallCut 300 için çevrimiçi göz atın veya pdf Kullanım Talimatları Kılavuzu indirin. Gardena SmallCut 300 12 sayfaları. Turbotrimmer
Ayrıca Gardena SmallCut 300 için: Kullanım Talimatları Kılavuzu (8 sayfalar), Kullanım Talimatları Kılavuzu (12 sayfalar), Operatör El Kitabı (9 sayfalar), Operatör El Kitabı (6 sayfalar)
Sayfayı Yazdır
D
E
7. Troubleshooting
Risk of injury !
Pulling the cutting filament
manually out of the filament
cassette :
G
5
Releasing a cutting filament
that has gone into the
cassette or which has fused :
E
G
Only use original GARDENA Filament Cassettes. You can
order Replacement Filament Cassettes from your GARDENA
dealer or directly from the GARDENA Customer Service.
• Filament Cassette for Turbotrimmer SmallCut 300 : Art. 5306
C
1. Unplug the mains plug.
2. Release the cassette cover
and remove the cover.
3. Remove the filament cassette
D
4. Remove any dirt.
5. Feed the cutting filament
through the hole
6. Insert the filament cassette
5
filament
when you do this.
F
7. Fit the cassette cover
D
clips
click into place.
v If the cassette cover
5
filament cassette
is completely in the filament cassette holder.
Risk of injury from the cutting filament !
V Always unplug the mains plug of the Turbotrimmer be-
fore troubleshooting.
A cutting filament that is too short or no longer extends auto-
matically when the trimmer is turned on can be pulled out
manually.
1. Unplug the cable from the mains.
2. Hold the automatic slide feed
the same time pull on the cutting filament
If the cutting filament has disappeared into the filament cassette
or if the automatic filament extension still doesn't work after pulling
the cutting filament
E
cassette
.
1. Unplug the cable from the mains.
2. Remove the filament cassette
6. Maintenance "Replacing the filament cassette" .
3. Unwind the cutting filament
and the cutting filament
onto the cassette
F
4. Clean the automatic mechanism lever
must move freely.
5
5. Insert the filament cassette again as described under
6. Maintenance "Replacing the filament cassette" .
C
by pressing both locking clips
E
.
5
of the new filament cassette
F
and pull out about 10 cm.
E
. Do not trap the cutting
C
so that you hear both locking
C
cannot be touched down, turn the
E
to and fro, until the filament cassette
G
down with your hand and at
5
it may be fused together in the filament
E
as described in
5
, clean the filament cassette
5
and wind the cutting filament
E
once more.
G
D
E
E
5
.
E
5
. The automatic lever
13