KitchenAid KHHC2090SBT3 Kurulum Talimatları Kılavuzu - Sayfa 10
Mikrodalga Fırın KitchenAid KHHC2090SBT3 için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. KitchenAid KHHC2090SBT3 12 sayfaları. Microwave hood combination
Ayrıca KitchenAid KHHC2090SBT3 için: Kullanıcı Talimatları (8 sayfalar)
Sayfayı Yazdır
For Roof Venting Installation Only
1. Insert damper assembly through the cabinet cutout so that the
long tab of the damper assembly slides into the slot on the left
side of the damper vent opening, as shown. Then secure with
mounting screw.
NOTE: The screw cannot be installed if the damper assembly is
not positioned as shown.
A
B
C
D
A. Long tab (inside slot)
B. Damper assembly
C. Mounting screw
D. Upper cabinet cutout
2.
Connect
vent to damper
assembly.
A
B
A. Vent
B. Damper assembly (under vent)
The grease and charcoal filters must be installed in the bottom of
the microwave hood combination.
See the User Instructions for
care and replacement information.
A
B
C
D
A. Retaining spring
B. Filter frame
C. Grease filter (metal)
D. Charcoal filter (black)
To Install Filters:
1. Make sure filters are stacked in the filter frame as shown
above.
2. Install the filters by inserting the wide tab of the filter frame
into the inner portion of the filter housing, then swinging the
outside of the frame up until it fits into place.
A
B
C
A. Filter frame
B. Wide tab
C. Microwave oven bottom
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension
cord.
Failure to follow these instructions can result in death,
fire, or electrical
shock.
1. Plug microwave oven into grounded 3 prong outlet.
2. Reconnect power.
3. Check the operation of microwave oven by placing 1 cup
(250 mL) of water on the turntable, and programming
a cook
time of 1 minute at 100% power. Test vent fan and exhaust by
operating the vent fan.
4. If the microwave oven does not operate:
•
Check that a household fuse has not blown, or that a
circuit breaker has not tripped. Replace the fuse or reset
the circuit breaker. If the problem continues, call an
electrician.
•
Check that the power supply cord is plugged into a
grounded 3 prong outlet.
•
See the User Instructions for troubleshooting
information.
Installation is now complete.
Save Installation Instructions for future use.
10