Makita 197413-5 Kullanım Kılavuzu - Sayfa 9

Matkap Makita 197413-5 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Makita 197413-5 13 sayfaları. Cordless cutter
Ayrıca Makita 197413-5 için: Kullanım Kılavuzu (13 sayfalar), Kullanım Kılavuzu (12 sayfalar)

Sayfayı Yazdır

NOTE: Use the proper bit for the head of the screw/

bolt that you wish to use.

NOTE: When fastening M8 or smaller screw, carefully

adjust pressure on the switch trigger so that the screw

is not damaged.

NOTE: Hold the tool pointed straight at the screw.

NOTE: If the impact force is too strong or you tighten

the screw for a time longer than shown in the figures,

the screw or the point of the driver bit may be over-

stressed, stripped, damaged, etc. Before starting your

job, always perform a test operation to determine the

proper fastening time for your screw.

The fastening torque is affected by a wide variety of

factors including the following. After fastening, always

check the torque with a torque wrench.

When the battery cartridge is discharged almost

completely, voltage will drop and the fastening

torque will be reduced.

Driver bit or socket bit

Failure to use the correct size driver bit or socket

bit will cause a reduction in the fastening torque.

Bolt

•

Even though the torque coefficient and the class

of bolt are the same, the proper fastening torque

will differ according to the diameter of bolt.

•

Even though the diameters of bolts are the

same, the proper fastening torque will differ

according to the torque coefficient, the class

of bolt and the bolt length.

The manner of holding the tool or the material

of driving position to be fastened will affect the

torque.

Operating the tool at low speed will cause a reduc-

tion in the fastening torque.

Using holster

Optional accessory

CAUTION:

When using the holster, remove a

driver bit/drill bit from the tool.

CAUTION:

Turn off the tool and wait until it

comes to a complete stop before placing it in the

holster.

Be sure to close the holster securely with the

holster button so that it holds the tool firmly.

Thread a waist belt or similar through holster holder.

► 1 . Holster holder 2. Waist belt

ster button.

You can keep two driver bits at the front of the holster.

MAINTENANCE

switched off and the battery cartridge is removed

before attempting to perform inspection or

maintenance.

NOTICE:

alcohol or the like. Discoloration, deformation or

cracks may result.

To maintain product SAFETY and RELIABILITY,

repairs, any other maintenance or adjustment should

be performed by Makita Authorized or Factory Service

Centers, always using Makita replacement parts.

9 ENGLISH

Put the tool in the holster and lock it with the hol-

CAUTION:

Always be sure that the tool is

Never use gasoline, benzine, thinner,