Makita 6041D Kullanım Kılavuzu - Sayfa 6
Matkap Makita 6041D için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Makita 6041D 14 sayfaları. Cordless driver drill
Ayrıca Makita 6041D için: Kullanım Kılavuzu (17 sayfalar)
Sayfayı Yazdır
Charging
Connect the charging plug to the charging
connector, then plug in the charger to the
power receptacle. Charging takes 3 hours.
CAUTION:
The battery in your new tool is not fully
charged. You will need to charge it before
use.
Do
not operate the tool during charging.
Overcharging more than
2
days consider-
ably shortens the battery service life.
Always unplug the charger after completing the charge.
1
Installing
or
removing driver
bit
CAUTION
:
When installing or removing the bit, be careful not to touch the trigger switch.
To install the bit, place
it
in the chuck
as
far
as it
will go.
Tighten the chuck by
hand. Place the chuck key in each of the
three holes and tighten clockwise.
Be sure to tighten all three chuck holes
evenly.
To remove the bit, turn the chuck key
counterclockwise
in
just one hole, then
loosen the chuck by hand.
-Chuck
kev
After use, return the chuck key to the
strorage cavity on the tool.
6