Makita 6071DW Kullanım Kılavuzu - Sayfa 6

Matkap Makita 6071DW için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Makita 6071DW 16 sayfaları. Cordless driver drill equipped with electric brake

Sayfayı Yazdır

Installing or removing battery cartridge

0Always switch off the tool before inser-

tion or removal of the battery cartridge.

.To remove the battery cartridqe, pull out

the set plate on the bottom i f the

tool

and grasp both sides

of the cartridge

while withdrawing

from the barrel.

.To insert the battery cartridge, align the

tongue on the battery cartridge with the

groove in the housing and slip

into

place. Snap the set plate back into place.

Be sure to close the set plate fully before

using the tool.

Do not use force when inserting the battery cartridge.

If the cartridge does not slide in easily, it is not being inserted correctly

Charging

Plug the fast charger into your power

source. Insert the battery cartridge

that

the plus and minus terminals on the bat-

tery cartridge are on the same sides as their

respective markings on the fast charger. In-

sert the cartridge fully into the port so that

it rests on the charger port floor.

The charging light will come on and charg-

ing will begin. If the charging light does not

come on, press the reset button. If the

Charmno lioht

. .

charging light goes out within 10 seconds even after pressing the reset button a couple of

times, the battery cartridge is dead. (CAUTION : Wait for more than

5 seconds after the

charging light goes out to press the reset button again.) Replace it with a new one. When

the charging light goes out after about one hour, you may remove the fully charged

battery cartridge. After charging, unplug the charger from the power source.

CAUTION :

Your new battery cartridge is not charged. You will need to charge it before use.

you try to charge a cartridge from a just-operated tool, sometimes the charging light

will not come on. If this occurs, let the cartridge cool off for a while. Then re-insert

it and try

charge it once more.

When you charge a new battery cartridge

a battery cartridge which has not been used

for a long period,

may not accept a full charge. This is a normal condition and does

not indicate a problem. You can recharge the battery cartridge fully after discharging

it almost completely a couple of times.

I f you wish to charge two battery cartridges, allow 15 minutes between chargings on the

fast charger.