Makita 6096D Kullanım Kılavuzu - Sayfa 7
Matkap Makita 6096D için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Makita 6096D 17 sayfaları. Cordless high speed drill equipped with electric brake
Ayrıca Makita 6096D için: Kullanıcı Kılavuzu (5 sayfalar), Kullanım Kılavuzu (9 sayfalar), Kullanım Kılavuzu (13 sayfalar)
Sayfayı Yazdır
FUNCTIONAL
DESCRIPTION
2
1. Button
2. Battery charger
1
2
1. Battery cartridge
2. Charging light
3. Battery charger
CAUTION:
•
Always be sure that the tool is switched off and the
battery cartridge is removed before adjusting or
checking function on the tool.
Installing or removing battery cartridge
002053
1
•
Always switch off the tool before insertion or removal of
the battery cartridge.
•
To remove the battery cartridge, withdraw it from the tool
while sliding the button on the side of the cartridge.
•
To insert the battery cartridge, align the tongue on the
battery cartridge with the groove in the housing and slip
it into place. Always insert it all the way until it locks in
place with a little click. If you can see the red part on the
upper side of the button, it is not locked completely.
Insert it fully until the red part cannot be seen. If not, it
may accidentally fall out of the tool, causing injury to you
or someone around you.
•
Do not use force when inserting the battery cartridge. If
the cartridge does not slide in easily, it is not being
inserted correctly.
Charging
004512
1. Plug the battery charger into the proper AC voltage
source. The charging light will flash in green color.
2. Insert the battery cartridge so that the plus and minus
terminals on the battery cartridge are on the same sides
3
as their respective markings on the charger. Insert the
cartridge fully into the port so that it rests on the charger
port floor.
3. When the battery cartridge is inserted, the charging light
color will change from green to red and charging will
begin. The charging light will remain lit steadily during
charging.
4. When the charging light color changes from red to
green, the charging cycle is complete.
5. If you leave the battery cartridge in the charger after the
charging cycle is complete, the charger will switch into
its "trickle charge (maintenance charge)" mode.
6. After charging, unplug the charger from the power
source.
7