Makita 6201D Kullanım Kılavuzu - Sayfa 6

Matkap Makita 6201D için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Makita 6201D 15 sayfaları. Cordless driver drill equipped with electric brake

Sayfayı Yazdır

Installing or removing battery cartridge

.Always switch off the tool before insertion or removal or the battery cartridge.

To remove the battery cartridge, pull out

the set plate on the tool and grasp both

sides of the cartridge while withdrawing it

from the tool.

To insert the battery cartridge, align the

tongue on the battery cartridge with the

groove in the housing and slip it into

place. Snap the

set

plate back into place.

Be sure t o close the set plate fully before

using the tool.

Battery cartridge

Do not use force when inserting the battery cartridge.

If the cartridge does not slide in easily,

i s not being inserted correctly.

Charging

Plug the fast charger into your power

source. Insert the battery cartridge so that

the plus and minus terminals on the bat-

tery cartridge are on the same sides as their

respective markings on the fast charger.

Insert the cartridge fully into the port

that it rests on the charger port floor.

Press the start button (red). The charging

light will come on and charging will begin.

If the charging light does not come on, press the reset button (yellow) first, then the start

button (red). If the charging light goes out within 10 seconds even after pressing the

reset button and s t a r t button a couple of times, the battery cartridge is dead. (CAUTION:

Wait for more than 5 seconds after the charging light goes out t o press the reset button

again.) Replace

with a new one. When the charging light goes out after about one our,

you may remove the fully charged battery cartridge.

After charging, unplug the charge from the power source.

CAUTION :

0Your new battery cartridge is not charged. You will need t o charge it before use.

* D o not keep the button pressed in with tape, etc. or the circuit will not function pro-

perly. Also, a malfunction of the charger may result possibly causing overheating, etc.

If you try t o charge a cartridge from a just-operated tool, sometimes the charging light

will not come on. If this occurs, l e t the cartridge cool off for

while. Then re-insert it

and try t o charge it once more.

When you charge a new battery cartridge or a battery cartridge which has not been used

for a long period, it may not accept a full charge. This i s a normal condition and does

not indicate

problem. You can recharge the battery cartridge fully after discharging

it almost completely a couple of times.

If you wish t o charge two battery cartridges, allow 15 minutes between chargings on the

fast charger.

Reset

button