Makita 6226DW Kullanım Kılavuzu - Sayfa 8

Matkap Makita 6226DW için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Makita 6226DW 19 sayfaları. 9.6 v i2 v 14.4 v
Ayrıca Makita 6226DW için: Kullanım Kılavuzu (19 sayfalar), Kullanım Kılavuzu (19 sayfalar), Kullanım Kılavuzu (19 sayfalar)

Sayfayı Yazdır

1. Functional Description

FUNCTIONAL DESCRIPTION

InstelUng or removing battery aartrldge

• Always switch off the tool before inser-

tion or removal of the battery cartridge.

=To remove the battery cartridge, with-

draw it from the tool while pressing the

buttons on both sides of the cartridge.

• To insert the battery cartridge, align the

tongue on the battery cartridge with the

groove in the housing and slip it into

place. Always insert it all the way until it locks in place with a little click. If not, it may

accidentally fall out of the tool, causing injury to you or someone around you.

• Do not use force when inserting the battery cartridge, if the cartridge does not slide in

easily, it is not being inserted correctly.

Charging

• Plug the battery charger into your power

source,

• Insert the battery cartridge so that the

plus and minus terminals on the battery

cartridge are on the same sides as their

respective

markings

the

battery

charger. Insert the cartridge fully into the

port so. that it rests on the charger port

floor.

• When the battery cartridge is inserted, the charging light color will flash in red color and

charging will begin.

• When charging is completed, the charging light goes out.

• If you leave the battery cartridge in the charger after the charging cycle is complete, the

charger will switch into its "trickle charge (maintenance charge)" mode.

• After charging, remove the battery cartridge from the charger and unplug the charger

from the power source.

CAUTION:

',The battery charger is for charging Makita battery cartridge. Never use it for other pur-

poses or for other manufacture's batteries.

• When you charge a new battery cartridge or a battery cartridge which has not been used

for a long period of time, it may not accept a full charge. This is a normal condition and

does not indicate a problem. You can recharge the battery cartridge fully after discharging

it completely and recharging a couple of times.

• When you charge a battery cartridge from a just-operated tool or a battery cartridge

which has been left in a lecation exposed to direct sunlight or heat for a long time,, let it

cool off. Then re-insert it end try to charge it once more.

• When you charge a new batten/cartridge or a battery cartridge which has not been used

for a long period, sometimes the charging light will go out soon. If this occurs, remove

the battery cartridge and re-lnsert it. If the che_ging light goes out within one minute even

after repeating this procedure a couple of times, the battery cartridge is deed. Replace it

with a new one.