Ceyear 4024D Bakım Kılavuzu - Sayfa 14

Ölçüm Cihazları Ceyear 4024D için çevrimiçi göz atın veya pdf Bakım Kılavuzu indirin. Ceyear 4024D 19 sayfaları. Spectrum analyzer

cable with the PC through the GPIB card, and connect 4024 to be tested with the PC through the

direct-connected network cable. It is as shown in the figure:

Open the temperature compensation software TempComp.exe, and the software interface is as

follows:

Click the Set Address button, and the communication address setting dialog will pop up. As shown in the

following figure, the GPIB address of the signal source to be connected, the GPIB Address of the power

meter and the IP Address of the spectrum analyzer can be set. The address of the signal source and

power meter can be inquired through 【System】 menu. If the GPIB number of the signal source is 19,

no modification is required; similarly, if the GPIB number of the power meter is 13, no modification is

required. The IP address of the spectrometer can be inquired through 【System】->[Network Config].

GPIB card

Signal source

2.4 mm cable

Fig. 9 Schematic Diagram of Connection

Fig. 10 TempComp Interface

GPIB cable

Adapter

Power meter

Power

Adapter

sensor