Makita 6237DWDE Teknik Bilgiler - Sayfa 10

Matkap Makita 6237DWDE için çevrimiçi göz atın veya pdf Teknik Bilgiler indirin. Makita 6237DWDE 13 sayfaları. Cordless driver drills 10mm, 13mm

epair

< 6 > Assembling speed change lever

1. Before assembling, make sure that 2 compression springs are installed in the speed change lever. See fig. 6.

2. Assemble speed change lever to the boss of gear assembly as illustrated in Fig. 6A.

3. After assembling, slide the speed change lever to the change ring side or yoke assembling side

and keep its slid position.

2 compression

springs

Change ring

side

Fig. 6

< 7 > Assembling mode change lever and housing

1. Hitch the hook of tension spring 2 to gear assembly and another hook to mode change lever as illustrated in Fig. 7.

2. Assemble mode change lever to gear assembly by inserting the boss of mode change lever into the groove

of gear assembly as illustrated in Fig. 7.

3. Assemble motor section (yoke, armature and endbell) to gear assembly. Assemble them to housing L as illustrated

in Fig. 7A.

Mode change lever

Tension spring 2

Fig. 7

Speed change

lever

Boss of

gear assembly

Yoke assembling side

Aligning the cut portion of

yoke with the boss of housing L,

assemble gear assembly and motor

section to housing L.

For assembling speed change lever,

approach from yoke assembling side.

And press speed change lever to the

boss of gear assembly.

Yoke assembling

side

Fig. 6A

Motor section

(yoke, armature and endbell)

Fig. 7A

P 10 / 13

Housing L