Alien RAIN SILVER Series Kurulum Talimatları - Sayfa 10

Endüstriyel Ekipmanlar Alien RAIN SILVER Series için çevrimiçi göz atın veya pdf Kurulum Talimatları indirin. Alien RAIN SILVER Series 12 sayfaları.

Planting into the system
The fabric pot sits inside the plastic pot. It is made of a thick composite
31
material and helps prevent the medium from entering into the system.
We recommend adding the medium to the pot once placed inside the
32
plastic pot. If filled outside of the pot the weight of the medium can
cause the walls of the pot to swell. The medium should be filled to
30mm below the top of the fabric to allow the fitting of the RAIN™ Lid.
Trim lower branches that are growing under the lid cover. If the plant
33
is not tall enough to protrude the lid cover, run the system without
the lid covers until the plants are tall enough.

SYSTEM OPERATION

Filling the system
Use a hose pipe to fill the tank. Add the required amount of
nutrients. After the first feed, top up the tank as some water will
remain in the system.
RAIN™ Brain
When you select a "Run -Time" position, the RAIN™ pump will engage.
When the selected "Run-Time" expires, the system will remain idle
until the next feed cycle which is selected by the "Frequency".
Frequency Dial
This is how often you require a feed cycle. It depends mostly on
the medium being used and the size of the plant. Soil may require
watering once every 1-3 days so the "24 - 72hr" setting would be
selected. Clay pebbles would be more in the range of once every 2-3
hours. Note, the RAIN™ system will require slightly less watering than
hand watering. This is due to the fact that the RAIN™ Lid and cover
purposely slow evaporation.
Run-time Dial
This is the amount of time that the RAIN™ pump will run. These
pumps have a high flow rate so the "Run-Time" is normally around
"30-60 seconds". This is a guide as mediums, moisture content and
desired run off times could require a slightly different setting.
For example, if you want to water the plants at 4pm every day for
34
60 seconds. At 4pm today, select "Frequency" 24hrs and then
"Run-Time" 60 seconds. The plants will be watered now and then
again tomorrow at 4pm.
10