Alien Aircraft Corp AE-502 Hızlı Başlangıç Kılavuzu - Sayfa 4

Oyuncak Alien Aircraft Corp AE-502 için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. Alien Aircraft Corp AE-502 6 sayfaları. Electric conversion

Sayfayı Yazdır

Building Instructions:

Building the electric powered version of the Taylorcraft 72 is almost identical to building the glow powered version.

The main difference between the models are the firewall/motor mount and the bottom hatch. As such, you should

follow the regular instruction manual to build the model with the following exceptions:

Step 14...The fuel tank tray is now the battery tray. After

assembly, glue velcro on the inside bottom.

Step 15...Replace F-21A and F-21B with E-02 and E-03. Glue

them together as shown. Glue the four E-04's to the front of

E-2. NOTE: The four E-04 spacers will mount the Himax

HC3528-0800 Brushless Motor in the proper position. If you

are using a different motor, measure from the plan to determine

haw many spacers are required for your installation.

Step 28, 29 and 30...Do not use parts F-17, F-18 and F-19 are

not used. Instead, position and glue part E-01 into place on the

bottom of the fuselage. Trim the rear edge if required to obtain

a good fit.

Step 32...You do not to drill the firewall as the holes are laser

cut. NOTE: If your motor uses a different mounting pattern,

Epoxy birch dowels in the holes and sand flush. Then drill

holes as required for your installation.

Step 33...Install the 6-32 blind nuts in the back in part E-03 and

secure with thin C/A glue.

Now continue with the remaining steps until step 50 when the fuselage is finished and sanded smooth.

Page 4