A&E Systems WeatherPro Oasis Elite Diyagnostik Servis Kılavuzu - Sayfa 8

Aksesuarlar A&E Systems WeatherPro Oasis Elite için çevrimiçi göz atın veya pdf Diyagnostik Servis Kılavuzu indirin. A&E Systems WeatherPro Oasis Elite 14 sayfaları.

Sayfayı Yazdır

Programming

Indicator Light

5.2 Programming Key FOB

The electronic board is susceptible to static

charge. Do not insert metal object inside con-

trol box. Damage to electronic board will oc-

cur if a short is created. Use only a noncon-

ductive material to depress programming

button inside control box.

5.2.1 Remove four (4) screws from control box

cover and lift cover to expose circuit

board.See FIG 5.2.

5.2.2 Press and release programming button .

Programming indicator light will illuminate.

5.2.3 Press and hold the key FOB patio awning

extend button for four (4) seconds.

5.2.4 Release the key FOB patio awning extend

button. This completes the programming

process.

5.2.5 Place control box cover on control box and

secure with four (4) screws .

5.2.6 Test awning operation.

SECTION 6 Auxiliary Cable

In Case Of Coach 12VDC Power Failure:

6.1. The WeatherPro hardware provides an auxiliary

power cable to connect the awning motor to an

external 12 VDC power source in case of power

failure in the coach. A good external 12 VDC

power source would be an automobile battery.

Access the motor and hardware cable connec-

tion located behind the wire cover at the top of

the right hand arm. Gently squeeze the sides to-

gether to remove. Unplug the connection.See

FIG. 6.1.

Programming

Button

FIG. 6.1

10' Auxiliary

Cable

SECTION 7 Emergency Retract Procedure

Patio Awning

Extend Button

Programming

Button

Connect the supplied 10 ft. harness directly to

the motor plug. Not the one in the hardware. Con-

nect the other end of the 10 ft. harness to a 12

VDC battery source. The red wire goes to + and

the black to –. This will retract the awning. To

avoid motor damage disconnect battery source

immediately after awning is fully retracted. The

awning can be extended by reversing the polar-

ity. Place the red wire on the – and the black wire

on the +. Again, remove wires immediately after

awning is fully extended.

Motor

Connector

Hardware

Connector

To Manually Close Awning:

7.1 Slide the pull strap (provided) into the utility slot

of the FRTA. See FIG. 7.1.

FIG. 5.2

Programming

Indicator Light

Wire

Cover