A&I Products A-C7481B Kurulum Kılavuzu - Sayfa 5

Çadır A&I Products A-C7481B için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. A&I Products A-C7481B 7 sayfaları.

If the ROPS measured 35" the side mount plates will mount directly to the canopy frame. The side mount

plates are reversible to accommodate forward and rear angled ROPS. The side mount plates are slotted, this

will allow adjustment to level the canopy once installed. The orientation of the side mount plates are shown

below (the curved edge will match the angle of the ROPS).

Fig. 2

The side mount plates will mount directly to the canopy frame with the (4) 3/8" bolts and (4) 3/8" nuts.

There are multiple positions to attach the side plates to the frame, this is determined by the angle of the

ROPS and personal preference. If the ROPS angles forward, use holes toward the center of the canopy frame.

If the ROPS angles to the rear, use holes towards the rear of the canopy frame. These are recommended, but

can be adjusted based on operator preference. After this step is complete move to step 7.

Fig. 3