A&L Furniture AL284C-UNF Montaj Talimatları
Dış Mekan Mobilyaları A&L Furniture AL284C-UNF için çevrimiçi göz atın veya pdf Montaj Talimatları indirin. A&L Furniture AL284C-UNF 2 sayfaları. 44” square walk-in table
Sayfayı Yazdır
Assembly Instructions for 44" Square Walk-In Table
Tools Needed:
Power drill or screwdriver
#2 Square Drive Bit
Hardware:
4 – 2¾" Wafer Head Bolts
75– 2" Screws
1 - Allen Wrench
Lay the table tops upside down & bolt together. Insert the four 2¾" bolts in the predrilled holes in one side
& turn into the threaded inserts with the Allen Wrench. (See photo 1.) Now, attach the 2"x2"x35" strips, use
six 2" screws in each strip. Turn into the predrilled holes and screw down into the table top. (See photo 2.)
Assemble the 4 bench legs. Take two leg supports and attach to a bench bottom. Put two 2" screws in the
predrilled holes in each end of the bench bottom and screw into one end of the leg supports. (See photo 3.)
Predrilled
holes in leg
supports
belong at
this end
Unfold a table leg assembly & place upside down on a table. (See photo 4.) Take a bench top & place up-
side down with the center 2x2 between the 2x4 table leg support beams. Attach with two 2" screws on
each side (See photos 4 and 5)
photo 1
photo 3
Parts List:
Table Top—2 pieces
2"x2"x35" Strips—2 pieces
Table Leg Assemblies—2 pieces
Bench Tops - 4 pieces
1"x5½"x14½" Bench Leg Supports—8 pieces
1"x5½"32" Bench Bottoms—4pieces
Step 1
Step 2
photo 4
Step 3
photo 2
*Keep 2x2 even with leg supports*
photo 5