A&R Power Amplifier SA200 Kullanıcı El Kitabı Kılavuzu - Sayfa 6

Amplifikatör A&R Power Amplifier SA200 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı Kılavuzu indirin. A&R Power Amplifier SA200 14 sayfaları. Stereo power amplifiers
Ayrıca A&R Power Amplifier SA200 için: Kullanıcı El Kitabı Kılavuzu (14 sayfalar)

Sayfayı Yazdır

Front Panel Controls

switch

Mains Power

To switch on the amplifier, depress the power on/off switch located on the extreme right of the

front panel until it latches home. The small rectangular LED (light emitting diode) adjacent to the

switch should glow green.

To turn off the power amplifier depress the power on/off switch again so that it unlatches.

The SA150 and SA200 generate very little in the way of undesirable switching surges into the

loudspeakers when they are turned on and off but they will faithfully amplify any surges generated

by preceding equipment. As the amplifiers are very powerful, these surges may cause damage to

certain loudspeakers through no fault of the power amplifier. Note that any A&R equipment likely

to be used with the SA150 or SA200 (e.g. C200 control unit or A60AP amplifier) is fully

suppressed, so that no switch on surge will occur. However, if your pre-amplifier is in any way-

suspect it is wise to turn on the power amplifier some moments after switching on the

pre-amplifier, in order to allow the pre-amplifier's circuits to settle down. Similarly, the power

amplifier should be turned off well before the preamplifier in order to allow its power supply to

discharge fully.

LED Overload Indicator

On both the SA150 and SA200 the front panel LED to the left of the power on/off switch

normally glows green to show that the DC power supplies in the amplifier are operating. It will

continue to glow green for a short time after the amplifier is switched off as the DC voltages decay.

On the SA200 only the LED also functions as an overload indicator. If either channel of the

SA200 clips or distorts significantly then the LED will change colour momentarily from green to

red. If the overload is maintained then the LED will glow red continuously and to avoid possible

speaker damage the preamplifier volume control should be turned down immediately.