Align-Pilates Combo Chair II Montaj Talimatları & Kullanım Kılavuzu - Sayfa 9

Fitness Ekipmanları Align-Pilates Combo Chair II için çevrimiçi göz atın veya pdf Montaj Talimatları & Kullanım Kılavuzu indirin. Align-Pilates Combo Chair II 12 sayfaları.

Sayfayı Yazdır

The Jump Board from the A2 Series can fit into the back of your Combo Chair II. This is an optional

extra that can be added at a later date.

Please read the below information before first use:

This combo chair is for indoor use only or an appropriate level surface of a non-slip nature. Should

the floor be slippery a non-slip mat should be used under the chair. The combo chair is not a toy

and should not be used by children without the guidance of a suitable qualified Pilates

professional.

Spring Adjustment

The higher the peg on the Spring Holder Tree the greater the spring resistance on the split pedals.

The lower the peg on the Spring Holder Tree the lighter the resistance and the lower the split

pedals will be to the floor. There are 4 spring positions, springs should be used at the same height

on each side of the same tree otherwise one of the springs will not be correctly tensioned and

the spring could come unattached from the tree. Always check springs are properly attached

and NEVER adjust whilst someone is on the equipment or the spring is under tension.

Splitting the Pedals

To split the pedals simply unscrew the Connecting Bar Fastener that is located under the pedals,

slide back the bar to separate the pedals and refasten to secure the Connecting Bar out of the

way. The pedals can now operate independently. To reconnect simply reverse this procedure.

Adjusting the Height of the Handles

Holding the upper part of the handle, loosen, but do not remove, the knob on the handle holder

then pull the knob out which will disengage the connector pin and allow you to adjust the height

of the handle. Release the knob when you get to the height you desire and continue to move

the handle until the locking pin locates in to one of the 9 height adjustment holes

available. Once located at the desired height tighten the knob to prevent and rattle and to fully

secure the handles.

Periodic Maintenance

We recommend that you check that all the bolts are properly tightened as part of your regular

maintenance routines. For cleaning upholstery we recommend cleaning with gym wipes from

vital-clean.de which are available worldwide. For further information on cleaning recommenda-

tions and equipment maintenance please visit our website: https://www.mad-hq.com/align-pi-

lates-resources and refer the Align-Pilates Routine Safety & Maintenance Guide

Spring Life

Please always check springs for signs of wear and tear before use. Springs showing any sign of

damage or which do not fully return to their closed position should be replaced immediately.

Align-Pilates should be changed at least every 2 years.