AEG 7000 Series Kullanıcı Kılavuzu - Sayfa 17

Fırın AEG 7000 Series için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. AEG 7000 Series 32 sayfaları.
Ayrıca AEG 7000 Series için: Kullanıcı Kılavuzu (44 sayfalar), Kullanıcı Kılavuzu (49 sayfalar), Kullanıcı Kılavuzu (32 sayfalar), Kullanıcı Kılavuzu (28 sayfalar), Kullanıcı Kılavuzu (36 sayfalar)

Sayfayı Yazdır

buttons and the program dial (this option

does not lock the On/Off button).

You can activate the child lock option:

• before you touch the Start/Pause

button - the appliance cannot start

• after you touch the Start/Pause

button - programs and option

selection is unavailable.

Child lock option activation:

1. Turn the dryer on.

2. Select 1 of the available programs.

3. Touch and hold down 2 buttons at

the same time.

The symbol

4. To deactivate the child lock, touch

the above buttons again until the

symbol disappears.

8.8 Starting a program

To start the program:

Touch the Start/Pause button.

The appliance starts and the LED above

the button stops flashing and stays on.

9. HINTS AND TIPS

9.1 Ecological hints

• Spin the laundry well before drying.

• Do not exceed the load sizes which

are specified in the programmes

chapter.

appears on the display.

8.9 Program change

To change a program:

1. Push the On/Off button to turn the

appliance off.

2. Push the On/Off button again to turn

on the appliance.

3. Set a new program.

8.10 Programme end

Clean the filter and drain the

water container after each

drying cycle. (See chapter

CARE AND CLEANING.)

If the drying cycle is finished, the symbol

appears on the display. If the Buzzer

option is activated, the acoustic signal

sounds intermittently for 1 minute.

If you do not turn off the

appliance, the anti-crease

phase starts (not active with

all programmes). Flashing

symbol signals the

execution of the anti-crease

phase. Laundry can be

removed during this phase.

To remove the laundry:

1. Push the On/Off button for 2 seconds

to turn the appliance off.

2. Open the appliance door.

3. Remove the laundry.

4. Close the appliance door.

Possible causes of unsatisfactory drying

results:

• Inadequate default dryness level

settings. See chapter

default dryness level

• Room temperature is too low or too

high. Optimal room temperature is

between 18°-25°C.

• Clean the filter after each drying

cycle.

• Do not use fabric softener to wash

and then dry. In the tumble dryer

laundry becomes soft automatically.

• The water from the water container

can be used to iron the clothes. You

ENGLISH

Adjustment of