Garmin 480 Hızlı Referans - Sayfa 14
GPS Garmin 480 için çevrimiçi göz atın veya pdf Hızlı Referans indirin. Garmin 480 25 sayfaları. Color gps/waas/nav/com
Ayrıca Garmin 480 için: Kullanıcı Bülteni (5 sayfalar), Kullanıcı Bülteni (6 sayfalar), Ek Uçuş El Kitabı (10 sayfalar)
Sayfayı Yazdır
USER WAYPOINTS (USER) / SYSTEM MODE (SYS)
User Waypoints (USER)
The GNS 480 can hold up to 500 user-defined waypoints. These waypoints can
be based on either lat/lon position or range and bearing from a reference point.
In the User Waypoint function, you can create new waypoint, edit existing ones,
or search for a User waypoint.
Creating or Editing a User Waypoint
1. Press FN and then the USER key to start the User Waypoint function. You
can also create User waypoint by
using the PAN function.
2. Press the NEW or EDIT key.
3. Use the Small and Large knobs
to name or edit the waypoint
name. You can also set a range
and bearing from a reference
waypoint.
4. Turn the Large knob to go to
each field on the page and edit the values.
5. Press Menu/Enter when finished.
Searching for a User Waypoint
1. Press FN and then the USER key to start the User Waypoint function.
2. Press the SEARCH key.
3. Use the Small and Large knobs to select the waypoint name. You can
also search through a given field by pressing the CRSR knob, moving to
a field with the Large knob, and then searching within a field by turning
the Small knob.
4. Press Menu/Enter when finished.
14
System Mode (SYS)
1. Press the FN key and then the SYS function smart key to reach the
System mode.
2. Press the GPS, VERS, or CNFG function smart keys to go to each page.
GPS
GPS/WAAS status, GPS Time, satellites
available with overhead view, and signal
strength of the available satellites are
shown.
VERS (Software Versions)
Unit serial number and software ver-
sions are shown. This information
should be noted before calling customer
service.
CNFG (User Configuration)
The User Configuration function allows
you to set values for your aircraft.
1. Turn the Large knob to highlight
the value.
2. Press the CRSR knob in and then
turn the Small knob to change
the value.
3. Press the Menu/Enter key to
save the value.