A+V Link Technologies AVM-6996H-SYS-A1 Hızlı Kurulum Kılavuzu - Sayfa 7

Alıcı A+V Link Technologies AVM-6996H-SYS-A1 için çevrimiçi göz atın veya pdf Hızlı Kurulum Kılavuzu indirin. A+V Link Technologies AVM-6996H-SYS-A1 8 sayfaları. Powerhdlink kit

Sayfayı Yazdır

A+V Link Technologies

Remote Controller Button Descriptions

Fig

Area

Top Row

Source

Volume

Setting

Name

Active/Power Saving

Link

Group

Factory (only for RX)

Select next source

Select HDMI-3

Select HDMI-2

Select HDMI-1

Select previous source

Select AV2

Select AV1

Not in use

Increase Volume (for RX)

Display (for RX)

PowerHDLink Quick Setup Guide

Toggles the states of the TX and RX between Active mode and Power

Saving mode. Power Saving mode is the state you can set the TX and

RX to when not in use. In Power Saving mode, the RX & TX stop

sending video to the TV monitors and then revert to a low-power state.

The Power Saving mode for the RX and TX are independent of each

other and must be set at their respective locations.

Reserved

Use this button if the RX and TX cannot establish a connection (cannot

be paired). You also need to use this button when adding an additional

RX to your existing RX/TX environment (or group.). This button is also

used to allow the RX/TX to reset the system to factory defaults.

Reserved

Selects next input source of the TX. Similar to the "Source" button on

the TX. It is used to switch from the current input source to next (e.g.

HDMI-1, HDMI-2, HDMI-3, AV1, AV2 etc).

Change current TX input source to HDMI-3

Change current TX input source to HDMI-2

Change current TX input source to HDMI-1

Move backwards to the previous TX input source. It is the opposite of

"Select next source".

Change current TX input source to AV2 (YPbPr)

Change current TX input source to AV1 (CVBS/S-Video)

Reserved

Increase audio volume on the receiver

Toggle TV system between 59.94 Hz (NTSC) and 50 Hz (PAL).

Description

Version 1.0