Garmin GPSMAP 800 Series Hızlı Başlangıç Kılavuzu - Sayfa 8

Araç Navigasyon sistemi Garmin GPSMAP 800 Series için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. Garmin GPSMAP 800 Series 17 sayfaları. Flat-mount kit
Ayrıca Garmin GPSMAP 800 Series için: Pilot El Kitabı Eki (22 sayfalar), Kullanıcı El Kitabı (40 sayfalar), Hızlı Başlangıç Kılavuzu (4 sayfalar), Kullanıcı El Kitabı (46 sayfalar), Kurulum Talimatları Kılavuzu (6 sayfalar), Operatör El Kitabı (32 sayfalar), Kurulum Talimatları Kılavuzu (34 sayfalar), Kurulum Talimatları Kılavuzu (6 sayfalar)

1. Connect the heart rate monitor

module

to the strap.

➊

2. Wet both electrodes

back of the strap to create a strong

connection between your chest and

the transmitter.

3. Wrap the strap around your chest,

and connect it.

The Garmin logo should be right-

side up.

4. Bring the device within range (3 m)

of the heart rate monitor.

TIP: If the heart rate data is erratic

or does not appear, you may have to

tighten the strap on your chest or warm

up for 5–10 minutes.

➊

on the

➋

After you put on the heart rate monitor,

it is on standby and ready to send data.

When the heart rate monitor is paired,

a message appears, and

solid on the status page.

installing the GSC 10

NOTE: If you do not have a GSC 10,

you can skip this task.

Both magnets must be aligned with

their respective indication lines for the

Edge to receive data.

1. Place the GSC 10 on the rear chain

stay (on the side opposite the drive

train).

NOTE: Place the flat rubber pad

or the triangle-shaped rubber pad

between the GSC 10 and the chain

stay for stability.

Edge 800 Quick Start Manual

appears

➊